There is no image on the screen.
Is the power indicator on the monitor blinking at 1 second intervals?
display will work properly but the
"Not Optimum Mode", "Recommended mode : 1600 X 1200 60Hz" message appears for one minute and then disappears. Please change to the recommended mode during this
(The message is displayed again if the system is rebooted.)
The monitor is in PowerSaver mode.
Press any key on the keyboard to activate the monitor and restore the image on the screen.
If there is still no image, press the 'SOURCE' button.
Then press any key on the keyboard again to activate the monitor and restore the image on the screen.
I cannot see the On Screen Display.
The screen shows strange colors or just black and white.
Is the monitor | You may get a blank screen if you |
connected using the | boot the system before you connect |
DVI cable? | the DVI cable, or disconnect and |
| then reconnect the DVI cable while |
| the system is running as certain |
| types of graphic cards do not send |
| out video signals. |
| Connect the DVI cable and then |
| reboot the system. |
Have you locked the On | Unlock the OSD by pressing the |
Screen Display (OSD) | MENU button for at least 5 seconds. |
Menu to prevent |
|
changes? |
|
|
|
Is the screen displaying | Check the signal cable connection. |
only one color as if | Make sure the video card is fully |
looking at the screen | inserted in it's slot. |
through a cellophane |
|
paper? |
|
Have the screen colors | Reboot the computer. |
become strange after |
|
running a program or |
|
due to a crash between |
|
applications? |
|
|
|
The screen suddenly has become unbalanced.
Has the video card been set properly?
Have you changed the video card or the driver?
Have you adjusted the resolution or frequency on the monitor?
Set the video card by referring to the video card manual.
Adjust screen image position and size using the OSD.
Adjust the resolution and frequency of the video card.
(Refer to the Preset Timing Modes).
The screen can be unbalanced due to the cycle of the video card signals. Readjust Position by referring to the OSD.
The screen is out of focus or OSD cannot be adjusted.
LED is blinking but no images on the screen.
Have you adjusted the resolution or frequency on the monitor?
Is the frequency properly adjusted when checking the Display Timing on the menu?
Adjust the resolution and frequency of the video card.
(Refer to the Preset Timing Modes).
Adjust the frequency properly by referring to the video card manual and the Preset Timing Modes.
(The maximum frequency per resolution may differ from product to