Technicolor - Thomson AV2-S, YPrPb, PC, YCrCb, AV1RGB important safety instructions

Page 3

20.Stand—Do not place the product on an unstable trolley, stand, tripod or table. Placing the product on an unstable base can cause the product to fall, resulting in serious personal injuries as well as damage to the product. Use only a trolley, stand, tripod, and bracket or table recommended by the manufacturer or sold with the product. When mounting the product on a wall, be sure to follow the manufacturer’s instructions.

Use only the mounting hardware recommended by the manufacturer.

21.Careful move— When relocating the product placed on a trolley, it must be moved with the utmost care. Sudden stops, excessive force and uneven floor surfaces can cause the product to fall from the trolley.

22.Panel protection—The LCD panel used in this product is made of glass.

Therefore, it can break when the product is dropped or impacted upon by other objects. Be careful not to be injured by broken glass pieces in case the LCD panel breaks.

On some models, the screen is protected by a glass shield. Under certain conditions (changes of temperature and humidity) moisture may form between the glass and the screen.

If this relatively rare condition arises, it is only necessary to switch on the LCD TV for around twenty minutes, to make it disappear.

23.Pixel defect—The LCD panel is a very high technology product, giving you finely detailed pictures. Occasionally, a few non-active pixels may appear on the screen as a fixed point of blue, green or red. Please note that this does not affect the performance of your product.

For added protection for this television equipment during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna. This will prevent damage to the equipment due to lightning and power-line surges.

An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can collide with such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits, as contact with them might be fatal.

3

Image 3
Contents Important Safety Instructions Page Page Important Information II Safety TipsBefore Setting Up AC Power Supply CordIV Caution If problems occur during useWhen using the LCD TV Do not handle the power cord plug with wet handsIntroduction Supplied AccessoriesPrecaution on battery use Batteries for the Remote ControlII Preparation Getting Started Switching onColoured buttons Remote control TV functionsUsing the remote control for other equipment Automatic code searchManual programming Automatic Installation Channels SET-UPInitial set-up Deleting channels OrganiserOrganiser Arranging channels in orderManual channel set-up Manual InstallationGeneral operation OperationBroadcast Options Adjusting the soundSound Return go back to Overview menuAdjusting the picture Phase, Synchronization, V-Position,H-PositionPicture TV Lock Setting the PreferencesSleep timer PreferencesNewsflash Accessing TeletextNavigation bar Changing the character set temporarilyDirect access to subpages SubtitlesFastext Sockets Other InformationComponent signal connection Connecting headphonesConnecting a video recorder Connecting a ComputerSymptoms Possible Causes TroubleshootingColors fade Antenna