OSD (On-Screen-Display) Controls
Channel Search
When powering on for the first time, you will be prompted to scan and memorize all available channels from your RF input signal. To start this process, press OPTION button to display the TV OSD menu.
NOTE: Digital channels are indicated with a
NOTE: When Channel Lock function is “On”, the Channel Search cannot be used. If Channel Lock is “On”, set it to “Off” before proceeding.
Auto Scan
Depending upon the RF input signal, you will need to scan for either off air (antenna) or cable channels.
Off Air Scan
1.On the “Tuner” menu page, press button to select “Channel Search” and press SET button. There are two
(1)Auto Scan
(2)Manual Scan
2.Select “Auto Scan” and press SET button.
3.Select “Off Air” and press SET button.
4.Press SET button to start channel scanning.
NOTE: It takes several minutes to complete the wholes scanning process; the percentage bar displays the progress.
5.When the scan has been completed, “Scan finish.” message will be displayed. Press OPTION or EXIT button to leave this window. Press CH+ and CH- buttons to verify the channels found and memorized. Cable Scan
1.Follow steps 1 to 2 listed above to activate the “Auto Scan” function for cable signals.
2.Select “Cable” and press SET button.
3.Press button and SET button to select “Cable Type”.
Select “STD”, “IRC” or “HRC” and press SET button.
NOTE: STD, IRC and HRC indentify various types of cable TV systems. Contact your local cable company for the type of cable system that exists in your particular area.
4. Press button to select ”Scan” and press SET button to start channel scanning.
NOTE: It takes several minutes to complete the wholes scanning process; the percentage bar displays the progress.
5.When the scan has been completed, “Scan finish.” message will be displayed. Press OPTION or EXIT button to leave this window. Press CH+ and CH- buttons to verify the channels found and memorized. Manual Scan
Manual Scan allows you to individually add new channels into memory without running Auto Scan.
1.On the “Channel Search” menu page, select “Manual Scan” and press SET button. There are two
(1)Off Air
For Off Air additions, enter the new channel number on the remote control’s numeric key pad. Press button to select “Scan”, and press SET button to scan for and load the channel.
(2)Cable
When adding Cable channels, verify your cable type, “STD”, “IRC” or “HRC”, and enter the new channel number on the remote control’s numeric keypad. Press button to select “Scan”, and press SET button to scan for and load the channel.
The scanned channels will appear if the desired scanning channel has been searched successfully.
2.When finished, press OPTION or EXIT button to leave this window.