<Instructions for Assembly, cont’d>
Connecting the Power Cord and System Cables
|
|
|
|
| Caution | Grip the plasma display firmly while connecting the power cord/system cables, as the display |
|
| may tip over and cause injury. |
| |
|
|
|
|
|
|
|
|
1.Check the Frame Fastening Screws.
Check that the two Frame Fastening Screws on the upper left and right sides of the Wall Mounting Unit are securely fastened.
Frame Fastening Screws
Caution
If the Frame Fastening Screws are not securely fastened the plasma display may fall, causing potentially fatal injury.
2.Place one hand on top of the plasma display to steady it and with the other hand set the Angle Adjustment Lever to 20° .
＊If the Angle Adjustment Lever has already been fastened, perform this task after removing the Angle Adjustment Lever Lock Screw.
20°
Caution
Grip the plasma display as you adjust the angle, as the plasma display may tip over and cause injury.
Angle Adjustment Lever
Lock Screw
10