Mounting the Wall Unit | Warning |
|
|
The Wall Mounting Unit should be mounted to a wall that can adequately
Plasterboard/Thin Plywood hold the total weight of the plasma display and the Wall Mounting Unit over a long period of time and which can adequately withstand
earthquakes, conceivable vibrations, and other external forces.
Improper installation may cause the plasma display to fall down, resulting in physical injury.
Mounting On Wooden Walls
The weight of the unit should be borne by the wall posts or studs, and these should be reinforced if insufficiently strong. Do not install the Wall Mounting Unit on walls made of plasterboard or thin plywood. Use the commercially sold screws best suited for the wall structure and material.
Mounting On Concrete Walls
Use commercially sold wall anchors capable of supporting the weight of the plasma display.
Do not install the Wall Mounting Unit in a location which is hot or humid or which may become wet, as the presence of excessive moisture may lead to fire or electric shock.
Do not install the Wall Mounting Unit near the blower or air inlet of an air conditioner.
Do not install the unit in a location with a large amount of dust, soot, or cigarette smoke, as this may lead to fire.
Do not install the Wall Mounting Unit in a location subject to frequent vibration, impact or other external forces.
The unit may fall down or
be damaged, causing
physical injury.
Do not install the unit in a location where people
may hang on it or lean
against it.
Doing so may cause the
unit to fall down or be
damaged, resulting in
injury.
|
| Do not block the |
|
| ventilation holes, and be |
| At least | sure to leave sufficient |
| ||
| 20 cm | space around the unit |
|
| for ventilation. |
At least | Inadequate ventilation may | |
15 cm | cause the unit interior to | |
|
| |
|
| overheat, leading to fire. |
Do not install the Wall
Mounting Unit on a
The unit interior may
overheat, resulting in fire,
or the unit may fall down,
causing physical injury.
Do not install the unit in a location exposed to direct sunlight or strong light, as viewing the plasma display in an overly bright environment can be tiring for the eyes.
3