ProSafe M4100 and M7100 Managed Switches

4.Continue with the boot of operational code.

5.Once the stack is up, download the saved configuration back to the master. This configuration should then be automatically propagated to all members of the stack.

Copy Master Firmware to a Stack Member (Web Interface)

1.Select System > Management > Basic > Stack Configuration. A screen similar to the following displays.

2.In the Copy Master Firmware to Unit list, select 2.

3.Click Apply.

Configure a Stacking Port as an Ethernet Port

AX742AX742

2/0/281/0/28

Figure 38. Configuring a stacking port as an Ethernet port

Follow these steps to set up the topology:

1.Insert the AX742 into the I/O module on the switch.

2.Configure the switch A and B as described in the following instructions.

3.Connect the AX 742 with stack cable.

4.Reboot Switch A and Switch B.

Chapter 19. Switch Stacks 355

Page 355
Image 355
NETGEAR M4100, M7100 Configure a Stacking Port as an Ethernet Port, Copy Master Firmware to a Stack Member Web Interface