NETGEAR M4100 Web Interface Configure a Stacking Port as an Ethernet Port, After Switch B reboots

ProSafe M4100 and M7100 Managed Switches

2.On Switch B, Configure the stack port and reboot.

(Netgear		Switch)	#
(Netgear Switch) #show stack-port					Configured Running			Link
					Stack	Stack	Link	Speed
Unit Intf		SlotId Type		XFP Adapter	Mode	Mode	Status	(Gb/s)
---- ----- ------ ------				-----------	-------	------	-----	-----
1	0/51		AX742	(stack)	Ethernet	Ethernet	Link Down	12
1	0/52		AX741		Ethernet	Ethernet	Link Down	10
(Netgear Switch)			#config
(Netgear Switch)			(Config)#stack
(Netgear Switch)			(Config-stack)#stack-port 1/0/51 ethernet
(Netgear Switch)			(Config-stack)#exit
(Netgear Switch)			(Config)#exit
(Netgear Switch)			#reload
Are you sure you			want to reload the stack? (y/n) y

After Switch B reboots:

(Netgear Switch) #show port 2/0/28
		Admin	Physical	Physical	Link	Link	LACP	Actor
Intf	Type	Mode	Mode	Status	Status	Trap	Mode	Timeout
------	-----	-------	-------- ---------		------	-------	------	------
1/0/51	Enable	10G Full 10G Full		Up	Enable	Enable	long

Web Interface: Configure a Stacking Port as an Ethernet Port

1.On Switch A, configure a stack port as an Ethernet port.

a.Select System > Stacking > Advanced > Stack Port Configuration. A screen similar to the following displays.

b.Under Stack Port Configuration, scroll down and select the 2/0/28 check box.

c.In the Configured Stack Mode list, select Ethernet.

d.Click Apply to save the settings.

2.Reboot the switch.

Chapter 19. Switch Stacks 357