NETGEAR M7100, M4100 CLI Show Igmp Querier Status, Web Interface Show Igmp Querier Status

ProSafe M4100 and M7100 Managed Switches

Show IGMP Querier Status

The example is shown as CLI commands and as a Web interface procedure.

CLI: Show IGMP Querier Status

To see the IGMP querier status, use the following command.

(Netgear Switch) #show igmpsnooping querier vlan 1

VLAN 1 : IGMP Snooping querier status
----------------------------------------------
IGMP Snooping Querier VLAN Mode	Enable
Querier Election Participate Mode	Disable
Querier VLAN Address	0.0.0.0
Operational State	Disabled
Operational version	2

The command shows that the IGMP admin mode is Active. The mode is controlled by the set igmp command. If the mode is inactive, no query packet is sent.

Web Interface: Show IGMP Querier Status

1.Select Switching > Multicast > IGMP Snooping Configuration. A screen similar to the following displays.

2.Click Refresh.

254 Chapter 13. IGMP Snooping and Querier