NETGEAR M4100, M7100 manual CLI Configure PIM-DM, PIM-DM on Switch a, Enable pimdm on the switch

ProSafe M4100 and M7100 Managed Switches

received by a router on its RPF interface, the state refresh message causes an existing prune state to be refreshed. State refresh messages are generated periodically by the router directly attached to the source. There are two versions of PIM-DM. Version 2 does not use IGMP messages; instead, it uses a message that is encapsulated in IP packets with protocol number 103. In version 2, the Hello message is introduced in place of the query message.

CLI: Configure PIM-DM

PIM-DM on Switch A

1.Enable IP routing on the switch.

(Netgear Switch) #configure (Netgear Switch) (Config)#ip routing

2.Enable pimdm on the switch.

(Netgear Switch) (Config)#ip pim dense

3.Enable IP multicast forwarding on the switch.

(Netgear Switch) (Config)#ip multicast

4.Enable RIP to build the unicast IP routing table.

(Netgear Switch) (Config)#interface 1/0/1 (Netgear Switch) (Interface 1/0/1)#routing

(Netgear Switch) (Interface 1/0/1)#ip address 192.168.2.2 255.255.255.0 (Netgear Switch) (Interface 1/0/1)#ip rip

Chapter 28. PIM 437