NETGEAR M4100, M7100 manual MLD on Switch B, Enable OSPFv3 to build a unicast route table

ProSafe M4100 and M7100 Managed Switches

(Netgear Switch) (Config)#ipv6 unicast-routing (Netgear Switch) (Config)#ipv6 pim dense (Netgear Switch) (Config)#ip routing (Netgear Switch) (Config)#ip multicast (Netgear Switch) (Config)#interface 1/0/1 (Netgear Switch) (Interface 1/0/1)#routing

(Netgear Switch) (Interface 1/0/1)#ipv6 address 2001:1::1/64 (Netgear Switch) (Interface 1/0/1)#ipv6 enable

(Netgear Switch) (Interface 1/0/1)#ipv6 pim dense (Netgear Switch) (Interface 1/0/1)#ipv6 ospf (Netgear Switch) (Interface 1/0/1)#exit

(Netgear Switch) (Config)#interface 1/0/13 (Netgear Switch) (Interface 1/0/13)#routing

(Netgear Switch) (Interface 1/0/13)#ipv6 address 2001:2::1/64 (Netgear Switch) (Interface 1/0/13)#ipv6 enable

(Netgear Switch) (Interface 1/0/13)#ipv6 pim dense (Netgear Switch) (Interface 1/0/13)#ipv6 ospf (Netgear Switch) (Interface 1/0/13)#exit

MLD on Switch B

1.Enable OSPFv3 to build a unicast route table.

(Netgear Switch)#configure

(Netgear Switch) (Config)#ipv6 router ospf (Netgear Switch) (Config-rtr)#router-id 2.2.2.2 (Netgear Switch) (Config)#exit

2.Enable IPV6 unicast routing on the switch.

(Netgear Switch) (Config)#ipv6 unicast-routing

3.Enable IPV6 MLD on the switch.

(Netgear Switch) (Config)#ipv6 mld router

4.Enable IPV6 PIM-DM on the switch.

(Netgear Switch) (Config)#ipv6 pim dense

Chapter 30. MLD 507