NETGEAR M7100, M4100 CLI Configure Vrrp on a Backup Router, Primary IP Address field, enter

ProSafe M4100 and M7100 Managed Switches

A screen similar to the following displays.

b.Under Global Configuration, next to the Admin Mode, select Enable radio button.

c.Enter the following information in the VRRP Configuration:

•In the VRID (1 to 255) field, enter 20.

•In the Interface field, select 1/0/2.

•In the Primary IP Address field, enter 192.150.2.1.

•In the Mode field, select Active.

d.Click Apply to save the settings.

VRRP on a Backup Router

The example is shown as CLI commands and as a Web interface procedure.

CLI: Configure VRRP on a Backup Router

1.Enable routing for the switch. IP forwarding will then be enabled by default.

(Netgear Switch) #config

(Netgear Switch) (Config)#ip routing

2.Configure the IP addresses and subnet masks for the port that will participate in the protocol.

(Netgear Switch) (Config)#interface 1/0/4 (Netgear Switch) (Interface 1/0/4)#routing

(Netgear Switch) (Interface 1/0/4)#ip address 192.150.4.1 255.255.0.0 (Netgear Switch) (Interface 1/0/4)#exit

3.Enable VRRP for the switch.

(Netgear Switch) (Config)#ip vrrp

132 Chapter 9. VRRP