NETGEAR M7100, M4100 manual Web Interface Configure Area 1 as a Stub Area on A1

ProSafe M4100 and M7100 Managed Switches

(Netgear Switch) (Config)#ex
(Netgear Switch) #show ip ospf neighbor interface all
Router ID	IP Address	Neighbor Interface	State
----------------	-----------	-------------------	---------
4.4.4.4	192.168.10.2	2/0/11	Full
2.2.2.2	192.168.20.2	2/0/19	Full

(Netgear Switch) #show ip route
Total Number of Routes			4
Network	Subnet		Next Hop	Next Hop
Address	Mask	Protocol	Intf	IP Address
---------------	---------------	------------	---------	---------------
14.1.1.0	255.255.255.0	OSPF Inter	2/0/11	192.168.10.2
14.1.2.0	255.255.255.0	OSPF Inter	2/0/11	192.168.10.2 192.168.10.0
255.255.255.0	Local	2/0/11	192.168.10.1
192.168.20.0	255.255.255.0	Local	2/0/19	192.168.20.1

Web Interface: Configure Area 1 as a Stub Area on A1

1.Enable IP routing on the switch.

a. Select Routing > IP > Basic > IP Configuration. A screen similar to the following displays.

b.For Routing Mode, select the Enable radio button.

c.Click Apply to save the settings.

2.Assign IP address 192.168.10.1 to port 2/0/11.

a.Select Routing > IP > Advanced > IP Interface Configuration.

100 Chapter 7. OSPF