ProSafe M4100 and M7100 Managed Switches

CLI: Enable Routing for Ports on the Switch

(Netgear Switch) #config

(Netgear Switch) (Config)#interface 1/0/2 (Netgear Switch) (Interface 1/0/2)#routing

(Netgear Switch) (Interface 1/0/2)#ip address 192.150.2.1 255.255.255.0 (Netgear Switch) (Interface 1/0/2)#exit

(Netgear Switch) (Config)#interface 1/0/3 (Netgear Switch) (Interface 1/0/3)#routing

(Netgear Switch) (Interface 1/0/3)#ip address 192.150.3.1 255.255.255.0 (Netgear Switch) (Interface 1/0/3)#exit

(Netgear Switch) (Config)#interface 1/0/5 (Netgear Switch) (Interface 1/0/5)#routing

(Netgear Switch) (Interface 1/0/5)#ip address 192.150.5.1 255.255.255.0 (Netgear Switch) (Interface 1/0/5)#exit

(Netgear Switch) (Config)#exit

Web Interface: Enable Routing for Ports on the Switch

1.Assign IP address 192.150.2.1/24 to interface 1/0/2.

a. Select Routing > IP > Advanced > IP Interface Configuration. A screen similar to the following displays.

b.Scroll down and select the interface 1/0/2 check box. Now 1/0/2 appears in the Interface field at the top.

c.Under the IP Interface Configuration, enter the following information:

In the IP Address field, enter 192.150.2.1.

In the Subnet Mask field, enter 255.255.255.0.

In the Routing Mode field, select Enable.

Chapter 4. Port Routing 63

Page 63
Image 63
NETGEAR M4100, M7100 manual CLI Enable Routing for Ports on the Switch, Web Interface Enable Routing for Ports on the Switch