NETGEAR M4100, M7100 manual CLI Configure Radius as the Verification Mode

ProSafe M4100 and M7100 Managed Switches

are used to configure captive portal. VSAs are denoted in the ID column and are comma delimited (vendor ID, attribute ID).

Table 3. RADIUS Attributes for Configuring Captive Portal Users

RADIUS Attribute	No.	Description	Range	Usage	Default
User-Name	1	User name to be authorized.	1–32 characters	Required	None
User-Password	2	User password.	8–64 characters	Required	None
Session-Timeout	27	Logout once session timeout is	Integer	Optional	0
		reached (seconds). If the attribute is	(seconds)
		0 or not present then use the value
		configured for the captive portal.
Idle-Timeout	28	Log out once idle timeout is reached	Integer	Optional	0
		(seconds). If the attribute is 0 or not	(seconds)
		present, then use the value
		configured for the captive portal.
WISPr-Max-Band	14122, 7	Maximum client transmit rate (b/s).	Integer	Optional	0
width-Up		Limits the bandwidth at which the
		client can send data into the network.
		If the attribute is 0 or not present,
		then use the value configured for the
		captive portal.
WISPr-Max-Band	14122, 8	Maximum client receive rate (b/s).	Integer	Optional	0
width-Down		Limits the bandwidth at which the
		client can receive data from the
		network. If the attribute is 0 or not
		present, then use the value
		configured for the captive portal.

CLI: Configure RADIUS as the Verification Mode

(Netgear Switch) (Config-CP 1)#radius-auth-server Default-RADIUS-Server (Netgear Switch) (Config-CP 1)#verification radius

Web Interface: Configure RADIUS as the Verification Mode

1.Select Security > Control > Captive Portal > CP Configuration.

Chapter 32. Captive Portal 549