NETGEAR M7100, M4100 manual Web Interface Configure Area 1 as an nssa Area on A1

ProSafe M4100 and M7100 Managed Switches

4.Enable area 0.0.0.1 on port 2/0/19.

(Netgear Switch) (Config-router)#exit (Netgear Switch) (Config)#interface 2/0/11 (Netgear Switch) (Interface 2/0/11)#routing

(Netgear Switch) (Interface 2/0/11)#ip address 192.168.10.1 255.255.255.0 (Netgear Switch) (Interface 2/0/11)#ip ospf

(Netgear Switch) (Interface 2/0/11)#exit (Netgear Switch) (Config)#interface 2/0/19 (Netgear Switch) (Interface 2/0/19)#routing

(Netgear Switch) (Interface 2/0/19)#ip address 192.168.20.1 255.255.255.0 (Netgear Switch) (Interface 2/0/19)#ip ospf

(Netgear Switch) (Interface 2/0/19)#ip ospf areaid 0.0.0.1

(Netgear Switch) (Interface 2/0/19)#exit
(Netgear Switch) (Config)#exit
(Netgear Switch) #show ip route
Total Number of Routes......................... 2
Network	Subnet		Next Hop	Next Hop
Address	Mask	Protocol	Intf	IP Address
---------------	---------------	------------	---------	---------------
14.1.1.0	255.255.255.0	OSPF Inter	2/0/11	192.168.10.2
14.1.2.0	255.255.255.0	OSPF Inter	2/0/11	192.168.10.2
192.168.10.0	255.255.255.0	Local	2/0/11	192.168.10.1
192.168.20.0	255.255.255.0	Local	2/0/19	192.168.20.1
192.168.40.0	255.255.255.0	OSPF NSSA T2	2/0/19	192.168.20.2
192.168.41.0	255.255.255.0	OSPF NSSA T2	2/0/19	192.168.20.2
192.168.42.0	255.255.255.0	OSPF NSSA T2	2/0/19	192.168.20.2

Web Interface: Configure Area 1 as an nssa Area on A1

1.Enable IP routing on the switch.

a. Select Routing > IP > Basic > IP Configuration. A screen similar to the following displays.

b.For Routing Mode, select the Enable radio button.

108 Chapter 7. OSPF