NETGEAR M4100 Set Up Vlan Routing for the VLANs and the Switch, Select Routing Vlan Vlan Routing

ProSafe M4100 and M7100 Managed Switches

Set Up VLAN Routing for the VLANs and the Switch

The example is shown as CLI commands and as a Web interface procedure.

CLI: Set Up VLAN Routing for the VLANs and the Switch

1.The following code sequence shows how to enable routing for the VLANs:

(Netgear Switch) #vlan data

(Netgear Switch) (Vlan)#vlan routing 10 (Netgear Switch) (Vlan)#vlan routing 20 (Netgear Switch) (Vlan)#exit

This returns the logical interface IDs that will be used instead of the slot/port in subsequent routing commands. Assume that VLAN 10 is assigned the ID 3/1, and VLAN 20 is assigned the ID 3/2.

2.Enable routing for the switch.

(Netgear Switch) #config

(Netgear Switch) (Config)#ip routing (Netgear Switch) (Config)#exit

3.The next sequence shows an example of configuring the IP addresses and subnet masks for the virtual router ports.

(Netgear Switch) (Config)#interface vlan 10

(Netgear Switch) (Interface-vlan 10)#ip address 192.150.3.1 255.255.255.0 (Netgear Switch) (Interface-vlan 10)#exit

(Netgear Switch) (Config)#interface vlan 20

(Netgear Switch) (Interface-vlan 20)#ip address 192.150.4.1 255.255.255.0 (Netgear Switch) (Interface-vlan 20)#exit

(Netgear Switch) (Config)#exit

Web Interface: Set Up VLAN Routing for the VLANs and the Switch

1.Select Routing > VLAN> VLAN Routing.

Chapter 5. VLAN Routing 73