ProSafe M4100 and M7100 Managed Switches

c.In the Port Selection Table, click Unit 1 to display all the ports.

d.Select the check box below Port 1.

e.Click Apply.

At the end of this configuration a screen similar to the following displays.

Configure IPv6 ACLs

This feature extends the existing IPv4 ACL by providing support for IPv6 packet classification. Each ACL is a set of up to 12 rules applied to inbound traffic. Each rule specifies whether the contents of a given field should be used to permit or deny access to the network, and can apply to one or more of the following fields within a packet:

Source IPv6 prefix

Destination IPv6 prefix

Protocol number

Source Layer 4 port

Destination Layer 4 port

DSCP value

Flow label

Chapter 10. ACLs 183

Page 183
Image 183
NETGEAR M4100, M7100 manual Configure IPv6 ACLs