NETGEAR M7100, M4100 manual CLI Configure Vlan Routing Ospf

ProSafe M4100 and M7100 Managed Switches

CLI: Configure VLAN Routing OSPF

This example adds support for OSPF to the configuration created in the base VLAN routing example in Figure 8, Layer 3 switch configured for port routing on page 69.

1.Configure the M4100 and M7100 Managed Switch as an inter-area router.

(Netgear Switch) #vlan data (Netgear Switch) (Vlan)#vlan 10 (Netgear Switch) (Vlan)#vlan 20 (Netgear Switch) (Vlan)#vlan routing 10 (Netgear Switch) (Vlan)#vlan routing 20 (Netgear Switch) (Vlan)#exit (Netgear Switch) #conf

(Netgear Switch) (Config)#ip routing

(Netgear Switch) (Config)#vlan port tagging all 10 (Netgear Switch) (Config)#vlan port tagging all 20 (Netgear Switch) (Config)#interface 1/0/2

(Netgear Switch) (Interface 1/0/2)#vlan participation include 10 (Netgear Switch) (Interface 1/0/2)#vlan pvid 10

(Netgear Switch) (Interface 1/0/2)#exit (Netgear Switch) (Config)#interface 1/0/3

(Netgear Switch) (Interface 1/0/3)#vlan participation include 20 (Netgear Switch) (Interface 1/0/3)#vlan pvid 20

(Netgear Switch) (Interface 1/0/3)#exit (Netgear Switch) (Config)#interface vlan 10

(Netgear Switch) (Interface vlan 10)#ip address 192.150.3.1 255.255.255.0 (Netgear Switch) (Interface vlan 10)#exit

(Netgear Switch) (Config)#interface vlan 20

(Netgear Switch) (Interface vlan 20)#ip address 192.150.4.1 255.255.255.0 (Netgear Switch) (Interface vlan 20)#exit

2.Specify the router ID and enable OSPF for the switch.

(Netgear Switch) (Config)#router ospf

(Netgear Switch) (Config router)#router-id 192.150.9.9 (Netgear Switch) (Config router)#enable

(Netgear Switch) (Config router)#exit

118 Chapter 7. OSPF