NETGEAR M7100, M4100 CLI Configure a Stacking Port as an Ethernet Port, After Switch a reboots

ProSafe M4100 and M7100 Managed Switches

CLI: Configure a Stacking Port as an Ethernet Port

1.On Switch A, Configure the Stack Port and Reboot

(Netgear Switch) #show stack-port				Configured Running			Link
				Stack	Stack	Link	Speed
Unit Intf SlotId Type			XFP Adapter	Mode	Mode	Status	(Gb/s)
---- ----- ------ ------			-----------	-------	------	-----	-----
2	0/27	None		Stack	Stack	Link Down	0
2	0/28	AX742	(stack)	Stack	Stack	Link Down	12
(Netgear Switch)		#config
(Netgear Switch)		(Config)#stack
(Netgear Switch)		(Config-stack)#stack-port 2/0/28 ethernet
(Netgear Switch)		(Config-stack)#exit
(Netgear Switch)		(Config)#exit
(Netgear Switch)		#reload
Are you sure you		want to reload the stack? (y/n) y

After Switch A reboots:

(Netgear Switch) #show		port 2/0/28
	Admin	Physical	Physical	Link	Link	LACP	Actor
Intf Type	Mode	Mode	Status	Status	Trap	Mode	Timeout
------ -----	-------	--------	---------	------	-------	-------	------
2/0/28	Enable	10G Full	10G Full	Up	Enable	Enable	long

356 Chapter 19. Switch Stacks