ProSafe M4100 and M7100 Managed Switches

Web Interface: Show classofservice Trust

Select QoS > CoS > Basic > CoS Configuration. A screen similar to the following displays.

Set classofservice Trust Mode

The example is shown as CLI commands and as a Web interface procedure.

CLI: Set classofservice Trust Mode

(Netgear Switch) (Config)#classofservice?

dot1p-mapping

Configure dot1p priority mapping.

ip-dscp-mapping

Maps an IP DSCP value to an internal traffic class.

trust

Sets the Class of Service Trust Mode of an Interface.

(Netgear Switch) (Config)#classofservice trust?

dot1p

Sets the Class of Service Trust Mode of an Interface

 

to 802.1p.

ip-dscp

Sets the Class of Service Trust Mode of an Interface

 

to IP DSCP.

(Netgear Switch) (Config)#classofservice trust dot1p?

<cr>

Press Enter to execute the command.

(Netgear Switch) (Config)#classofservice trust dot1p

Web Interface: Set classofservice Trust Mode

1.Select QoS > CoS > Basic > CoS Configuration. A screen similar to the following displays.

Chapter 11. CoS Queuing 193

Page 193
Image 193
NETGEAR M4100, M7100 manual Web Interface Show classofservice Trust, CLI Set classofservice Trust Mode