NETGEAR M7100, M4100 Web Interface Configure Area 1 as a Stub Area on A2, Set the router ID to

ProSafe M4100 and M7100 Managed Switches

2.Set the router ID to 2.2.2.2.

(Netgear Switch) (Config-router)#router-id 2.2.2.2

3.Configure area 0.0.0.1 as a stub area.

(Netgear Switch) (Config-router)#area 0.0.0.1 stub

4.Enable OSPF area 0.0.0.1 on the 1/0/15.

(Netgear Switch) (Config-router)#exit

(Netgear Switch) (Config-router)#exit (Netgear Switch) (Config)#interface 1/0/15 (Netgear Switch) (Interface 1/0/15)#routing

(Netgear Switch) (Interface 1/0/15)#ip address 192.168.20.2 255.255.255.0 (Netgear Switch) (Interface 1/0/15)#ip ospf

(Netgear Switch) (Interface 1/0/15)#ip ospf areaid 0.0.0.1

(Netgear Switch) (Interface 1/0/15)#exit (Netgear Switch) (Config)#exit (Netgear Switch) #show ip route

Total Number of Routes			2
Network	Subnet		Next Hop	Next Hop
Address	Mask	Protocol	Intf	IP Address
---------------	---------------	------------	---------	---------------
0.0.0.0	0.0.0.0	OSPF Inter	1/0/15	192.168.20.1
192.168.20.0	255.255.255.0	Local	1/0/15	192.168.20.2

Web Interface: Configure Area 1 as a Stub Area on A2

1.Enable IP routing on the switch.

a. Select Routing > IP > Basic > IP Configuration. A screen similar to the following displays.

104 Chapter 7. OSPF