NETGEAR M7100, M4100 manual Routing for the Switch, Network with RIP on ports 1/0/2 and 1/0/3

ProSafe M4100 and M7100 Managed Switches

Layer 3 sIwitch acting as a router

Port 1/0/2	Port 1/0/5
192.150.2.2	192.64.4.1

Port 1/0/3 192.130.3.1

Subnet 2 Subnet 3 Subnet 5

Figure 9. Network with RIP on ports 1/0/2 and 1/0/3

Routing for the Switch

The example is shown as CLI commands and as a Web interface procedure.

CLI: Enable Routing for the Switch

(Netgear Switch) #config

(Netgear Switch) (Config)#ip routing (Netgear Switch) (Config)#exit

Web Interface: Enable Routing for the Switch

1.Select Routing > IP > Basic > IP Configuration. A screen similar to the following displays.

2.For Routing Mode, select the Enable radio button.

76 Chapter 6. RIP