NETGEAR M7100 Stub Areas, CLI Configure Area 1 as a Stub Area on A1, Enable routing on the switch

ProSafe M4100 and M7100 Managed Switches

A screen similar to the following displays.

b.Under Interface Configuration, scroll down and select the interface 1/0/4 check box. Now 1/0/4 appears in the Interface field at the top.

•In the OSPF Area ID field, enter 0.0.0.2.

•In the OSPF Admin Mode field, select the Enable.

•In the Priority field, enter 255.

•In the Metric Cost field, enter 64.

c.Click Apply to save the settings.

Stub Areas

The example is shown as CLI commands and as a Web interface procedure.

Layer 3			Layer 3
switch	Port 2/0/191	Port 1/0/151	switch
Port 2/0/11
Area 0	Area 1

Figure 12. Area 1 is a stub area

CLI: Configure Area 1 as a Stub Area on A1

1.Enable routing on the switch.

(Netgear Switch) #config

(Netgear Switch) (Config)#ip routing

98 Chapter 7. OSPF