NETGEAR M4100, M7100 manual IP precedence to queue mapping of the interface is displayed

ProSafe M4100 and M7100 Managed Switches

The IP precedence to queue mapping of the interface is displayed.

Configure Cos-queue Min-bandwidth and Strict Priority Scheduler Mode

The example is shown as CLI commands and as a Web interface procedure.

CLI: Configure Cos-queue Min-bandwidth and Strict Priority Scheduler Mode

(Netgear Switch) (Config)#cos-queue min-bandwidth?

<bw-0>Enter the minimum bandwidth percentage for Queue 0.

(Netgear Switch) (Config)#cos-queue min-bandwidth 15
Incorrect input! Use 'cos-queue min-bandwidth <bw-0>..<bw-7>.
(Netgear Switch) (Config)#cos-queue min-bandwidth 15 25 10		5	5 20 10 10
(Netgear Switch) (Config)#cos-queue strict?
<queue-id>	Enter a Queue Id from 0 to 7.
(Netgear Switch) (Config)#cos-queue strict 1?
<cr>	Press Enter to execute the command.
<queue-id>	Enter an additional Queue Id from	0	to 7.

(Netgear Switch) (Config)#cos-queue strict 1

Web Interface: Configure CoS-queue Min-bandwidth and Strict Priority Scheduler Mode

1.For Interface 1/0/2, set the minimum bandwidth to 15 for queue 0.

a. Select QoS > CoS > Advanced > Interface Queue Configuration. A screen similar to the following displays.

b.In the Queue ID list, select 0.

Chapter 11. CoS Queuing 195