NETGEAR M4100, M7100 manual Enable OSPFv3, and assign 1.1.1.1 to router ID

ProSafe M4100 and M7100 Managed Switches

2.Enable OSPFv3, and assign 1.1.1.1 to router ID.

(Netgear Switch) (Config)#ipv6 router ospf (Netgear Switch) (Config-rtr)#enable (Netgear Switch) (Config-rtr)#router-id 1.1.1.1 (Netgear Switch) (Config-rtr)#exit

3.Enable routing mode on the interface 1/0/1, and assign the IP address 2000::1 to IPv6,.

(Netgear Switch) (Config)#interface 1/0/1 (Netgear Switch) (Interface 1/0/1)#routing

(Netgear Switch) (Interface 1/0/1)#ipv6 address 2000::1/64 (Netgear Switch) (Interface 1/0/1)#ipv6 enable

4.Enable OSPFv3 on the interface 1/0/1, and set the OSPF network mode to broadcast.

(Netgear	Switch) (Interface		1/0/1)#ipv6 ospf
(Netgear	Switch) (Interface		1/0/1)#ipv6 ospf network broadcast
(Netgear	Switch) #show	ipv6	ospf	neighbor
Router ID	Priority	Intf	ID	Interface	State	DeadTime
---------- --------		-------		---------	--------------	-------
2.2.2.2	1	13		1/0/1	Full/BACKUP-DR	34

5.On A2, enable IPv6 unitcast routing on the switch.

(Netgear Switch) (Config)#ipv6 unicast-routing

6.Enable OSPFv3, and assign 2.2.2.2 as the router ID.

(Netgear Switch) (Config)#ipv6 router ospf (Netgear Switch) (Config-rtr)#enable (Netgear Switch) (Config-rtr)#router-id 2.2.2.2 (Netgear Switch) (Config-rtr)#exit

7.Enable routing mode on interface 1/0/13, and assign the IP address 2000::2 to IPv6.

(Netgear Switch) (Config)#interface 1/0/13 (Netgear Switch) (Interface 1/0/13)#routing

(Netgear Switch) (Interface 1/0/13)#ipv6 address 2000::2/64 (Netgear Switch) (Interface 1/0/13)#ipv6 enable

Chapter 7. OSPF 123