ProSafe M4100 and M7100 Managed Switches

CLI: Set CoS Trust Mode for an Interface

(Netgear Switch) (Interface

1/0/3)#classofservice trust?

dot1p

Sets the Class of Service Trust Mode of an Interface

 

to

802.1p.

ip-dscp

Sets the Class of Service Trust Mode of an Interface

 

to

IP DSCP.

(Netgear Switch) (Interface

1/0/3)#classofservice trust dot1p?

<cr>

Press Enter to execute the command.

(Netgear Switch) (Interface

1/0/3)#classofservice trust dot1p

Note: The traffic class value range is 0–-6 instead of 0–-7 because queue 7 is reserved in a stacking build for stack control, and therefore you cannot configure it.

Web Interface: Set CoS Trust Mode for an Interface

1.Select QoS > CoS > Advanced > CoS Configuration. A screen similar to the following displays.

2.Under CoS Configuration, select the Interface radio button.

3.In the Interface list, select 1/0/3.

4.In the Interface Trust Mode list, select trust dot1p.

5.Click Apply to save the settings.

Configure Traffic Shaping

Traffic shaping controls the amount and volume of traffic transmitted through a network. This has the effect of smoothing temporary traffic bursts over time. Use the traffic-shape

Chapter 11. CoS Queuing 197

Page 197
Image 197
NETGEAR M4100, M7100 manual Configure Traffic Shaping, CLI Set CoS Trust Mode for an Interface