NETGEAR M4100, M7100 manual Enable RIP for the switch Route preference defaults to

ProSafe M4100 and M7100 Managed Switches

(Netgear Switch) (Config)#ip routing

(Netgear Switch) (Config)#vlan port tagging all 10 (Netgear Switch) (Config)#vlan port tagging all 20 (Netgear Switch) (Config)#interface 1/0/2

(Netgear Switch) (Interface 1/0/2)#vlan participation include 10 (Netgear Switch) (Interface 1/0/2)#vlan pvid 10

(Netgear Switch) (Interface 1/0/2)#exit (Netgear Switch) (Config)#interface 1/0/3

(Netgear Switch) (Interface 1/0/3)#vlan participation include 20 (Netgear Switch) (Interface 1/0/3)#vlan pvid 20

(Netgear Switch) (Interface 1/0/3)#exit (Netgear Switch) #config

(Netgear Switch) (Config)#interface vlan 10

(Netgear Switch) (Interface vlan 10)#ip address 192.150.3.1 255.255.255.0 (Netgear Switch) (Interface vlan 10)#exit

(Netgear Switch) (Config)#interface vlan 20

(Netgear Switch) (Interface vlan 20)#ip address 192.150.4.1 255.255.255.0 (Netgear Switch) (Interface vlan 20)#exit

2.Enable RIP for the switch.

The route preference defaults to 15.

(Netgear Switch) (Config)#router rip (Netgear Switch) (Config router)#enable (Netgear Switch) (Config router)#exit

3.Configure the IP address and subnet mask for a nonvirtual router port.

(Netgear Switch) (Config)#interface 1/0/5

(Netgear Switch) (Interface 1/0/5)#ip address 192.150.5.1 255.255.255.0 (Netgear Switch) (Interface 1/0/5)#exit

4.Enable RIP for the VLAN router ports.

Authentication defaults to none, and no default route entry is created.

(Netgear Switch) (Config)#interface vlan 10 (Netgear Switch) (Interface vlan 10)#ip rip (Netgear Switch) (Interface vlan 10)#exit (Netgear Switch) (Config)#interface vlan 20 (Netgear Switch) (Interface vlan 20)#ip rip (Netgear Switch) (Interface vlan 20)#exit (Netgear Switch) (Config)#exit

Chapter 6. RIP 83