ProSafe M4100 and M7100 Managed Switches

nssa Areas

Layer 3

 

 

Layer 3

switch

Port 2/0/191

Port 1/0/151

Switch

Port 2/0/11

 

Area 0

Area 1

 

Figure 13. nssa Area

The example is shown as CLI commands and as a Web interface procedure.

CLI: Configure Area 1 as an nssa Area

1.Enable routing on the switch.

(Netgear Switch) #config

(Netgear Switch) (Config)#router ospf (Netgear Switch) (Config)#ip routing

2.Configure area 0.0.0.1 as an nssa area.

(Netgear Switch) (Config)#router ospf

(Netgear Switch) (Config-router)#router-id 1.1.1.1 (Netgear Switch) (Config-router)#area 0.0.0.1 nssa

3.Stop importing summary LSAs to area 0.0.0.1.

(Netgear Switch) (Config-router)#area 0.0.0.1 nssa no-summary

Chapter 7. OSPF 107

Page 107
Image 107
NETGEAR M4100, M7100 manual Nssa Areas, CLI Configure Area 1 as an nssa Area, Configure area 0.0.0.1 as an nssa area