NETGEAR M7100, M4100 manual CLI Configure Private-VLAN Host Ports

ProSafe M4100 and M7100 Managed Switches

d.Click Apply to save the settings.

2.Configure ports 1/0/2-1/0/5 to host port mode.

a.Select Security > Traffic Control > Private VLAN > Private VLAN Port Mode Configuration.

A screen similar to the following displays.

b.Under Private VLAN Port Mode Configuration, select the 1/0/2 to 1/0/5 interface check box.

c.In the Port VLAN Mode field, select Host from the pull-down menu.

d.Click Apply to save the settings.

Configure Private-VLAN Host Ports

The example is shown as CLI commands and as a Web interface procedure.

CLI: Configure Private-VLAN Host Ports

Use the following commands to associate isolated ports 1/0/2-1/0/3 to a private-VLAN (primary=100, secondary=101). Community ports 1/0/4-1/0/5 to a private-VLAN (primary= 100, secondary=102).

(Netgear Switch)	#config
(Netgear Switch)	(Config)#interface 1/0/2-1/0/3
(Netgear Switch)	(Interface 1/0/2-1/0/3)#switchport private-vlan host-association 100 101
(Netgear Switch)	(Interface 1/0/2-1/0/3)#exit
(Netgear Switch)	(Config)#interface 1/0/4-1/0/5
(Netgear Switch)	(Interface 1/0/4-1/0/5)#switchport private-vlan host-association 100 102
(Netgear Switch)	(Interface 1/0/4-1/0/5)#end

50 Chapter 2. VLANs