IP ROUTING NETWORK WITH REMOTE BRIDGE DEVICES
Verify the Installation
CONFIGURING THE
The default configuration for
CONFIGURING THE NETWORK LOGIN INFORMATION
This network doesn’t require the use of a user level database so network login information configuration is not necessary.
SAVE CONFIGURATION FILES
We have now configured all necessary information. Press 4 from the Main menu to save the changes. The old configuration files will be stored in the \CONFIG directory with a file extension of .BAK (i.e., the old NODE.NEI file will be called NODE.BAK).
After you save the configuration files, press <RET> to exit the CFGEDIT program. Reboot the system to activate your changes.
VERIFY THE INSTALLATION
Steps on how to verify the installation are detailed in the System Verification chapter of the User’s Guide. This section gives an outline of which steps should be executed.
On the CyberSWITCH:
Verify hardware resources are operational
Issue dr command
Look for BRI line messages
Look for LAN initialized messages
Check for IP routing initialized message
Verify WAN Lines Available
Connect WAN lines
Issue dr command
Look for “Data Link up 1,1” in reports
On each Remote LAN:
•Attempt to access a resource on the CyberSWITCH LAN. This may require that you reboot your system and proceed through the logon sequence.
•Have the remote hosts ping the CyberSWITCH.
•Have the CyberSWITCH ping the remote hosts (if a connection is up).
Workgroup Remote Access Switch 57
