EXAMPLE NETWORKS
four calls/connections running in parallel). Configure a
Device ISDN Menu: (Device = "dallasnet")
1) | ISDN Line Protocol | "PPP (Point to Point Protocol)" | |
2) | Base Data Rate | "64000 bps" | |
3) | Initial | Data Rate | "64000 bps" |
4) | Maximum | Data Rate | "256000 bps" |
5) | Dial Out Phone Number(s) | "912143339999" | |
6) | Subaddress | "" | |
7) | Profile | Name | "Default_Profile" |
8) | H0 Call | Support | DISABLED |
Select function from above or <RET> for previous menu: <RET>
Authentication Information
From the Device Table Menu, select Authentication. Add the Dallas site’s PAP password, which is dnpswd.
IPX Information
From the Device Table Menu, select IPX. From this configuration menu, insure that IPX routing and Make calls for IPX data are enabled. You may then enable IPXWAN protocol:
|
|
|
|
|
|
| Device IPX Menu: (Device = "dallasnet") |
|
| ||
| 1) | IPX Routing | ENABLED |
|
|
| 2) | Make calls for IPX data | ENABLED |
|
|
| 3) | IPXWAN Protocol | DISABLED |
|
|
| 4) | Routing Protocol | None |
|
|
| 5) | Spoofing Options |
|
|
|
| Select function from above or <RET> for | previous menu?3 |
| ||
| Use the IPXWAN protocol for this device | (Y or N) [default = N] ? Y |
| ||
|
|
|
|
|
|
|
|
|
|
|
|
Next, select Routing Protocol. For this example, we will use the triggered RIP/SAP protocol, and select a WAN Peer Type of ACTIVE:
IPX Device Routing Protocol
1)None
2)RIP/SAP
3)Triggered RIP/SAP
Enter selection or press <RET> for previous menu [default=None}: 3
1)Active
2)Passive
Triggered RIP/SAP WAN Peer type [default=ACTIVE]: 1
Finally, there is no need to change the default Spoofing Options. Return to the Device Table Menu.
86 CyberSWITCH
