APPLETALK ROUTING NETWORK
Configure the CyberSWITCH
CONFIGURING DEVICE SITE2’S AUTHENTICATION INFORMATION
At the Device Table Menu, select Authentication. You may then enter the authentication information needed for this device. The information needed for each device depends on the device type.
For device SITE2, because we will be configuring CHAP security, we will configure a CHAP secret (ikcd98s). After the secret has been entered, the Device Authentication Menu will appear as follows:
Device Authentication Menu: (Device = "SITE2")
PPP: |
|
|
1) | PAP Password | "" |
2) | CHAP Secret | "ikcd98s" |
3) | Outbound Authentication | ENABLED |
4) | User Level Authentication | DISABLED |
IP Host (RFC 1294): |
| |
5) | IP Host Id | "" |
HDLC Bridge: |
| |
6) | Bridge Ethernet Address | "" |
7) | Bridge Password | "" |
ISDN: |
|
|
8) | Calling Line Id(s) | "" |
Select function from above or <RET> for previous menu:
Again, return to the Device Table Menu.
CONFIGURING DEVICE SITE2’S APPLETALK INFORMATION
To begin the configuration of device SITE2’s AppleTalk information, select AppleTalk from the Device Table menu. A menu will then be displayed with preconfigured default values. as shown below:
Device AppleTalk Menu: (Device = "SITE2")
1) | AppleTalk Address | None | |
2) | AppleTalk | Routing | DISABLED |
3) | Make calls for AppleTalk data | DISABLED | |
4) | AppleTalk | Routing Protocol | None |
Select function from above or <RET> for previous menu:
To complete the AppleTalk configuration for device SITE2:
•Select AppleTalk Address. Because this device is over an unnumbered link, enter 0.0 for the Ap- pleTalk address.
•Select AppleTalk Routing. Follow the
•Select Make calls for AppleTalk Data. Follow the
Workgroup Remote Access Switch 103
