Cabletron Systems 1200, 1000 manual Before beginning, note the following

IP ROUTING NETWORK

Configure the CyberSWITCH

CONFIGURING THE DEVICE LEVEL DATABASE

Before beginning, note the following:

The Device Name is the symbolic name for the Device. The Host Id is the information that will be exchanged when the call is received to ensure only the proper Devices gain access to the system. The IP Address is simply the IP Address for the device. The IP address must have a valid IP network interface defined for it.

Press 3 at the Security Menu to display the Device Level Database Menu. To enable the On-node Device Database, press 1 and follow the on-screen instructions.

To add the remote devices, press 2 (On-node Device Database entries). Press 1 to configure the information for our first device, Rick Bear:

Device Name? Rick Bear

After the new device name has been specified, a screen similar to the following is displayed. Select 1, ISDN:

Device Table Menu: (Device = "Rick Bear")

1)ISDN

2)Frame Relay

3)X.25

4)Authentication

5)IP

6)IPX

7)AppleTalk

8)Bridging

9)Compression

Select function from above or <RET> for previous menu: 1

The ISDN Configuration Menu then displays preconfigured default values:

Device ISDN Menu: (Device = "Rick Bear")

1)	ISDN Line Protocol.		"PPP (Point to Point Protocol)"
2)	Base Data Rate.		"64000 bps"
3)	Initial	Data Rate.	"64000 bps"
4)	Maximum	Data Rate.	"128000 bps"
5)	Dial Out Phone Number(s). ""
6)	Subaddress.		""
7)	Profile	Name.	"Default_Profile"
8)	H0 Call	Support	DISABLED

Select function from above or <RET> for previous menu:

We do not want to use the default ISDN Line Protocol of PPP. Press 1 to configure this device’s ISDN line protocol. The device Rick Bear uses RFC 1294 protocol, so we will press 3:

Workgroup Remote Access Switch 41