Cabletron Systems 1000, 1200 Configure The Cyberswitch, Example Networks, Configuring The Options

EXAMPLE NETWORKS

CONFIGURE THE CYBERSWITCH

Note: The software should have already been installed and you need the system prompt before proceeding with these steps.

Using the detailed instructions for these steps found in the Simple Remote Bridging chapter, complete the following configuration steps for SITE1.

Start the CFGEDIT program

Select physical resources

Select to add a resource

Select Switch type to be NI-1

Select to add a line

Enter the line name

Select slot and port numbers

Select line interface type of “Point-to-Point”

Add Data Links (Data Link explanation follows)

Choose Auto TEI Negotiation

Enter Service Profile ID (SPID) Value

Enter Directory Number for Data Link

Enter Maximum Number of Digits to Verify

Repeat “Add Data Links” for second Data Link

Repeat “Select to add a line” for each additional line

Data links are handled differently on a NI-1 switch. Some BRI lines have only one phone number (for the Data Link), but can handle two calls (one for each bearer channel). For NI-1 switches, the BRI line has two phone numbers (one for each bearer channel), and each phone number has its own SPID. You must enter the number of digits to verify, so that when the system receives a phone call it can determine on which bearer to accept the phone call. Refer to the System Details worksheet for the SPIDs, directory numbers, and the number of digits to verify.

The sections below provide instructions for completing the remaining configuration steps for SITE1.

CONFIGURING THE OPTIONS

By default, AppleTalk Routing is disabled. Before we can begin configuring the AppleTalk feature, we must first enable AppleTalk Routing. From the Options Menu, select AppleTalk Routing (Enable/ Disable). Follow the onscreen instructions to enable AppleTalk Routing. The following expanded screen will then be displayed:

AppleTalk Routing Menu:

1)AppleTalk Routing (Enable/Disable)

2)AppleTalk Ports

3)AppleTalk Static Routes

4)Isolated Mode (Enable/Disable)

Select function from above or <RET> for previous menu:

We will use this menu to configure SITE1’s AppleTalk information.

98 CyberSWITCH