Mitsubishi Electronics LT-37131 Sleep Timer, Care, Battery Installation, Low Battery Indicator

Chapter 3. TV Operation 37

Remote Control, continued

	1
	2		5
	3
	4
			6
	7		11
	8		12
	9
	10		13
			14
			15
			18
	16		19
	17		20
23	24	25	21
26	27	28
	22

Figure 1. Remote Control Overview

1

2

Figure 2. The remote control requires two AA alkaline batteries.

Sleep Timer

Setting the Sleep Timer

1.Press SLEEP on the remote control.

2.Press SLEEP additional times to increase the time in 30- minute increments up to the maximum of 120 minutes.

3.Press EXIT or wait five seconds without pressing any buttons for the message to disappear.

4.Press SLEEP to view the time remaining before the sleep timer turns off the TV.

Cancelling the Sleep Timer

1.Press SLEEP to display the on-screen message.

2.Press SLEEP repeatedly until OFF is displayed.

Note: After five seconds of inactivity, the message box will disappear.

Care

For Best Results from the Remote Control:

•Use only alkaline batteries.

•Be within 20 feet of the equipment.

•Do not press two or more buttons at the same time unless instructed to do so.

•Do not allow unit to get wet or become heated.

•Avoid dropping on hard surfaces.

Battery Installation

•Do not use harsh chemicals to clean. Use only a soft, lightly moistened cloth.

1.Remove the remote control’s back cover by gently pressing in the tab and lifting off the cover (Figure 2).

2.Load the batteries, making sure the (+) and (-) polarities are correct. For best results, insert the negative (-) end first.

3.Snap the cover back in place.

Low Battery Indicator

•Do not mix old and new batteries.

•Do not heat, take apart, or throw batteries into fire.

Resetting the Remote Control

If the slide switch is set to TV and the TV does not respond properly, do the following to reset the remote control.

1.Press and hold POWER for several seconds until the button blinks twice and goes off.

If the POWER button blinks five times after you have pressed 2.		Release the POWER button.
any button, the remote control batteries are low and should	3.	Press keys 0 0 9 3 5 . The POWER button will blink twice
be replaced.
		when you finish entering the code.