Mitsubishi Electronics WD-57833 manual About NetCommand, Important Note on NetCommand

54

6 NetCommand

About NetCommand

•NetCommand setup is optional.

•You can perform NetCommand setup when the TV first recognizes a device during Auto Input Sensing or at any convenient time afterward.

•NetCommand operates by sending remote control signals from the TV to your other devices via the IR emitters, telling the devices to play, record, change inputs, adjust volume, change channels, or perform other functions. All this is accomplished with the TV’s remote control and the slide switch left in the TV position.

•The IR “Learning” feature of NetCommand allows the TV to determine the IR control signals for your A/V devices.

•NetCommand® can control IEEE 1394 devices by sending control signals over a FireWire® cable.

•You can choose the level of NetCommand control for your home theater.

Important Note on NetCommand

Be sure to connect the IR emitter cable to the TV and properly place the emitters so that Netcommand can control your devices. See the explanation on the following page.

Standard Setup. Perform a standard setup if you:

Want NetCommand to control only a few devices, such as the TV, a playback device (like a DVD player), and a cable box. With this setup, you can use the TV’s remote control to operate these devices.

Want the ease and flexibility of NetCommand-controlled recording, with seamless setup of time-delayed or immedi- ate recordings among networked devices.

Want to use TV Guide On Screen to control your VCR or A/V disc. After performing this setup, you can use the TV’s remote control to operate these devices.

A/V Receiver Setup. Perform A/V receiver setup if you want NetCommand to:

Control a surround sound A/V receiver.

Automatically change audio input selections on an A/V receiver when you change inputs on the TV.