Mitsubishi Electronics WD-57833 manual Appendices

88	Appendices
IEEE 1394 Devices
	Symptom	Remarks
5.	There is no audio and video from the IEEE	•	The device is not turned on. Turn the device power on.
	1394 device.	• No tape is inserted in the DVCR.
		• The media is blank (has no recording).
		• The play command failed. Try pressing PLAY again on the
			device’s remote control or front panel.
		• The device is already in use (for example, the device is cur-
			rently recording).
		• The source is copy-protected or violates copy protection.
		• The device’s digital video signal is not supported by the TV,
			as may be the case with an IEEE 1394 signal from a com-
			puter. Use analog connections instead, if available.
		• The device is not an audio/video device.
		• Too many other devices are already communicating over IEEE
			1394. Remove or stop some devices and try again.
6.	The IEEE 1394 device cannot be selected (is	•	The device may be busy with a recording. Cancel the recording.
	grayed out).	• You have connected more than seven IEEE 1394 devices.
			Unplug the eighth device and one other device. Plug the new
			device back in.
7.	All IEEE 1394 devices disappear.	• The connected devices must not be in a loop that returns to
			the TV. Make sure a device is connected at the end.
		• Disconnect all the cables and devices from the TV. Replace
			them one by one to locate the problem device or cable.
		• Use System Reset (front control panel).
8.	An IEEE 1394 device has been plugged in	• The IEEE 1394 connection to the TV or another device is not
	but does not appear in the Input Selection		secure or is loose.
	menu (not discovered).	• The IEEE 1394 device is not powered on.
		• A device in the IEEE 1394 chain is not powered on. Turn on
			all the devices.
		• The device discovery can take as long as a minute to initiate.
		•	IEEE 1394 cable is too long (maximum of 15 feet between
			devices).
		• The IEEE 1394 device uses an incompatible protocol and will
			not be discovered
9.	An IEEE 1394 device is not responding	•	Unplug the device’s power cord. Wait at least ten seconds
	properly.		and plug it in again.
		• Some IEEE 1394 devices are not supported by the TV
			because of incompatible standards.