Mitsubishi Electronics WD-57833 manual TV Back Panel

1. Television Overview

TV Back Panel

12 11 10 9

3D GLASSES

EMITTER

IEEE 1394

ANT 2 / AUX	DIGITAL
ANT 1 / MAIN	AUDIO
	OUTPUT

RS-232C	IR EMITTER
	NetCommand

COMPONENT 1

COMPONENT 2

RECORD

OUTPUT

INPUT 1

INPUT 2

HDMI

1 (LEFT) , 2 (MIDDLE) , 3 (RIGHT)

VIDEO: 480i / 480p / 720p / 1080i / 1080p

AUDIO: LINEAR PCM

PC: VGA, W-VGA, SVGA, W-SVGA, XGA, W-XGA, SXGA / 720p / 1080p

Y Pb Pr (480i/480p/720p/1080i)

Y Pb Pr L (MONO)- AUDIO - R

AUDIO-

LEFT

AUDIO-

VIDEORIGHT

S-VIDEO VIDEO L (MONO)- AUDIO - R

DVI / PC AUDIO INPUT

AVR AUDIO OUTPUT

1 2 3 4 5

6 7 8

1. ANT 1/MAIN, ANT 2/AUX (Antenna)

If you are connecting an antenna or direct cable without a cable box, connect the main antenna or cable source to ANT 1/MAIN. Use ANT 2/AUX for a second source.

ANT 1/MAIN and ANT 2/AUX can each receive digital and analog over-the-air channels from a VHF/UHF antenna or non-scrambled digital/analog cable source.

2. DIGITAL AUDIO OUTPUT

This output sends Dolby Digital or PCM digital audio to your digital A/V surround sound receiver. Analog audio from analog channels and devices is converted by the TV to PCM digital audio. If you have a digital A/V receiver, in most cases this is the only audio connection needed between the TV and your A/V receiver.

3. RS-232C

Use the RS-232C interface to receive control signals from compatible home-theater control devices.

4. IR Emitter NetCommand

IR Emitters connected to this jack are used by the TV’s NetCommand system to control external IR remote controlled analog devices such as cable boxes, VCRs, DVDs, satellite receivers and audio receivers.

5. IEEE 1394 (also known as Firewire®)

These jacks allow the TV to connect to external IEEE 1394 digital products by means of a single cable. See chapter 6, “NetCommand” for information regarding IEEE 1394 connections and recording.

6. INPUT (audio and video; front and rear)

Input jacks can be used to connect a VCR, Super VHS (S-VHS) VCR, DVD player, standard satellite receiver, or other A/V device to the TV. The INPUT groups on the back of the TV consist of jacks for composite video, S-Video, and analog stereo audio. Note that when you connect to the S-video jack, the composite video jack is automatically disabled. INPUT 3 is a third set of com- posite video and stereo audio jacks located on the front of the TV for convenience.