Mitsubishi Electronics L75-A91, L75A81 manual Appendix D TV Care, Cleaning Recommendations

Page 78

76Appendices

Appendix D: TV Care

Cleaning Recommendations

Normally, light dusting with a dry, non-scratching duster will keep your TV clean. If cleaning beyond this is needed, please use the following guidelines:

First, turn off the TV and unplug the power cord from the power outlet.

Occasionally clean dust build-up from the air-intake grilles on the back and sides of the TV. Clean using a vacuum cleaner with a brush attachment.

Top and Sides of the TV

Gently wipe down your TV with a soft, non-abrasive cloth such as cotton flannel or microfiber, or a clean cloth diaper, lightly moistened with water. Dry with a second dry, soft, non-abrasive cloth.

For oily dirt, add a few drops of mild liquid deter- gent, such as dishwashing detergent, to the water used to moisten the cloth. Rinse with a second cloth moistened only with water. Dry with a third dry, soft, non-abrasive cloth.

Screen

Follow the instructions for the top and sides, wiping gently in an up and down motion.

Clean the entire screen evenly, not just sections of the screen.

Do not allow liquid to drip down the screen, as some liquid may enter the TV through the gap between the screen and screen frame.

You may purchase Mitsubishi Screen Cleaner, part number CLEANER-VSS, by calling (800) 553-7278.

General Cleaning Precautions

DO NOT allow liquid to enter the TV through the ventilation slots or any crevice.

DO NOT use any strong or abrasive cleaners, as these can scratch the surfaces.

DO NOT use any cleaners containing ammonia, bleach, alcohol, benzene, or thinners, as these can dull the surfaces.

DO NOT spray liquids or cleaners directly on the TV’s surfaces.

DO NOT scrub or rub the TV harshly. Wipe it gently.

Care of the Remote Control

Remote Control Tips

For longer life, use alkaline batteries.

Do not mix old and new batteries.

Be within 20 feet of the equipment.

Do not press two or more keys at the same time unless instructed to do so.

Do not allow the unit to get wet or become heated.

Keep the unit out of direct sunlight.

Avoid dropping on hard surfaces.

Do not use harsh chemicals to clean. Use only a soft, lightly moistened cloth.

Resetting the Remote Control

If TV mode is selected and the TV does not respond properly, reset the remote control.

1.Press and hold POWER for several seconds until the mode indicator blinks twice and goes off.

2.Release the POWER key.

3.Press keys 0 0 9 3 5 and the mode indicator will blink twice when you finish entering the code. When entering the code, pause for a moment between each key press to ensure it is recognized.

Low-Battery Indicator

If you press a key and the mode indicator blinks five times, replace the remote control’s batteries.

In Canada call 1(800) 450-6487 for assistance.

Image 78
Contents Owner’s Guide Page U.S. call 1877 675-2224 for assistance Stand RequirementChildren and Television Viewing Replacement Parts Canada call 1800 450-6487 for assistanceOutdoor Antenna Grounding Safe Operation Laser SafetyLaser Safety Damage and RepairInstallation and Operating Notes Contents Package Contents Remote Control BatteriesSpecial Features of Your TV TV Controls and Indicators Remote ControlSystem Reset TV Control PanelPanel-Lock Release Power Indicator LED Color TV Condition Additional InformationBefore You Begin First-Time Power-OnPower-On TV TipsSetting Up Other Inputs Setting Up TV InputsUsing the ANT Antenna Input Memorizing Channels with Channel Scan For the ANT inputAbout Auto Sensing Selecting an Input to Watch CancelBasic TV Operation Watching Broadcast TVOther TV Features Making Picture AdjustmentsAudio Settings Other InformationComputer Video Connection Audio Using the TV with a Personal ComputerConnecting a Computer to the TV ConnectionComputer Display Formats Computer Video AdjustmentsImage Resolution Distortion in Computer ImagesBefore You Begin Cable ManagementInputs and Outputs RS-232C LAN USBa Hdmi Inputs High-Definition Multimedia InterfaceUSB Hdmi Cable CategoriesPb Pr Component Video Device Hdmi DeviceHdtv Cable Box, Satellite Receiver, DVD/ Blu-ray Player Composite Video Device Antenna or Cable TV ServiceDVI Video Device Cable Box, Satellite Receiver, DVD PlayerVCR or DVD Recorder to a Cable Box VCR or DVD Recorder to an Antenna or Wall Outlet CableReceiver Receiver with Hdmi OutputDVD player Viewing the Sleep Timer Sleep TimerSetting the Sleep Timer Selecting an InputControlling A/V Receiver Sound Volume ChannelView Channel ListingsRedirecting Audio Output Standard-Definition Analog Channels Status DisplayAbout Channel Numbers Standard-Definition Digital ChannelsDVD Image Definitions TV Signals and Display FormatsSignal Definitions TV Display Format Definitions3D Video Signal Assign Source Name Initial SetupTo Watch Regular non-3D Content 3D Video3D Safety Requirements EpilepsyPlaying a Slide Show or Playlist Camera and Music FilesUSB Media Player Menu Displaying the MenuThumbnail and Playlist Menus USB Media Setup Menu Picture Files Compatible with the USB PortSlideshow + Music --Slideshow Music only Using an Audio-Only Device Camera Images and Music FilesPhotos and Moving Video As Composite Video Vudu Wireless Kit Streaming Internet Movies with VuduStandard Connection Troubleshooting Getting StartedIntroduction to Home-Theater Control Source device connected directly to the TVMain Menu Menu NavigationAdjust From the Adjust Picture menuFrom the Adjust Audio menu SAPEnter twice ResetFilm Mode Auto, Off Advanced Picture Global Video Mute3D Mode On, Off Using PerfectColorUsing PerfecTint This setting applies only to the current inputCaptions Captions on Analog ChannelsCaptions on Digital Channels Initial DSTChannel Ant Air Adding/Deleting Channels Using the Channel Edit MenuUsage Fast Power Ant CableInputs AVRDVD DVD2 DVR How is the Activity Menu Generated?Photos Music USB VCR VuduLock TV-G ParentalTV-Y TV-PGUnlock Time Lock by TimeLock Time PanelAbout NetCommand IR Control Important Note on NetCommandIR Emitter Placement Leave IR-NetCommand Output selectedIf You are Unable to Locate a Device’s IR Sensor Initial NetCommand Setup Adding or Removing Device Keys from NetCommand ControlIf the device has no Power OFF key, skip this step Controlling Most Device Types Operating NetCommand-Controlled DevicesSpecial Operation Description and Setup How to Use Special Operation MethodsMore Key Menu and NetCommand SP/EPNetCommand Specialized Device Keys Controlling Other A/V Receiver Functions Switching Audio to and from the A/V ReceiverControlling A/V Receiver Power With Any Connection TypeSetup to Control A/V Receiver Power and Volume Setting Up A/V Receiver ControlPower and Volume Before You BeginAutomatic Audio or Audio/Video Switching Digital surround sound Case 3 Automatic Audio Video Switching via Hdmi More About Using an Hdmi ConnectionBefore You Begin Open the Inputs Learn menu Canada call 1800 450-6487 for assistance Appendices More Menus Appendix a Programming the Remote ControlFunctions Available for Other A/V Devices L75-A91 Supplemental KeysDVD Programming the Remote ControlAudio Lock Universal A/V Receiver Control CABLE/SAT VCR DVD AudioProgramming Codes Audio AmplifiersCable Boxes Satellite Receivers VCRsKEC GFMHI-Q KTVDVD and Blu-ray Players JMB GPXIRT JSIMitsubishi Laservue TV Bypassing the Parental LockL75-A81 L75-A91 This page intentionally left blank Has No Hdmi Control Option Appendix C Hdmi Control of CEC DevicesEnabling Hdmi Control of CEC Devices Device does not have CEC compatibility ActionHdmi Control of an Hdmi A/V Receiver and Connected Devices Device Found screen, highlight OnUsing Hdmi Control Resolving CEC ConflictsCleaning Recommendations Care of the Remote ControlAppendix D TV Care Appendix E Troubleshooting Reset Name When to Use How to Use Resulting ActionInitial Channel Edit menu Read the ON-SCREEN If the New DeviceNew Device Found screen TionsGeneral TV Operation Symptom Remarks TV Channels from the ANT input Symptom Remarks TV Power On/Off Symptom RemarksPicture Symptom Remarks Sound Symptom RemarksReceiver Set Up for Audio and Video Switching over NetCommand IR Control L75-A91 Symptom RemarksReceiver Set Up for Audio-Only Switching Receiver with Hdmi ControlAppendices83 Trademark and License Information Mitsubishi TV Software GNU General Public License No Warranty Mitsubishi Laservue Television Limited Warranty U.S.A. only To Obtain Warranty ServiceThis Limited Warranty does not Cover Mitsubishi Digital Electronics AMERICA, INCMitsubishi Laservue Television Limited Warranty Canada only MescaWarranty91 Index HdmiIndex93 VuduPage Page System Reset