Mitsubishi Electronics L75A81 manual Programming the Remote Control, Dvd, CABLE/SAT VCR DVD Audio

Appendices65

Appendix A: Programming the Remote Control, continued

Programming the Remote Control

1.Press the side button on the remote control to change to the correct mode for the product you want to control. Refer to the table below. Only one of each device type can be controlled in each mode.

Mode	Available Device
Cable/SAT	Cable Box
	DTV Receiver
	Satellite Receiver
VCR	VCR
	DVR
	DVD Player/Recorder
DVD	DVD Player/Recorder
	DVR
	VCR
Audio	A/V Receiver
	Audio Amplifier
	CD Player

2.Press and hold POWER on the remote control for several seconds until the mode indicator blinks twice and goes off.

3.Release the POWER key.

4.Enter the first five-digit code listed for your equip- ment.

•The mode indicator blinks twice when you start to enter the code and then once for each additional keypress.

•The mode indicator blinks twice when you finish entering a valid code.

•If you need to start over or wish to exit pro- gramming mode, temporarily change to a different mode using the side button.

5.Point the remote control at the equipment and press POWER. If the product has no power on/off

function, press a different key, such as (Play),

(Stop), VOLUME UP, or MUTE.

•If the equipment responds, the remote control is properly programmed.

•If the equipment does not respond, repeat steps 2–4 with the next five-digit code listed for your equipment.

6.Once you have found the correct code, write it in the space below for future reference.

Mode	Device Type	Code
CABLE/SAT
VCR
DVD
AUDIO

IMPORTANT

You may need to reprogram the remote control after changing the batteries. Record the codes for each mode in the space provided to make this faster.

Code Verification

To determine the code programmed for any mode:

1.Set the mode to the one you wish to verify.

2.Press and hold POWER on the remote control for several seconds until the mode indicator blinks twice and goes off.

3.Press keys 9 9 0

4.Press 1 and count the blinks of the power key. Write down the number of blinks as the first digit of the code.

5.Repeat step 4 for the second, third, fourth, and fifth digits of the code.

Audio Lock: Universal A/V Receiver Control

With Audio Lock enabled, the remote control operates volume and mute on the A/V receiver in all modes set by the side button. Activate Audio Lock if you always use an A/V receiver with your TV and other A/V equipment.

1.Program AUDIO mode for your A/V receiver as described in “Programming the Remote Control” on this page.

2.With the remote control in AUDIO mode, hold POWER on the remote control for several seconds until the mode indicator blinks twice and goes off.

3.Press keys 9 9 3 ENTER

The mode indicator will blink twice to indicate Audio Lock is active.

To Reset the Remote Control to Operate Volume and Mute for the TV Speakers

1.Press and hold POWER for several seconds until the mode indicator blinks twice and goes off.

2.Press keys 9 9 3 VOLUME UP.

The mode indicator will blink four times to indicate Audio Lock has cleared.

In the U.S. call 1(877) 675-2224 for assistance.