How to use as PC Monitor
1.Turn on the PDP and press 
on the remote controller.
2.Use 
to select RGB1(Analog) and then press 
. (If the PC output is set to Digital, select RGB2(Digital).)
3.This PDP does not support Plug & Play function. When setting the PDP, select default.
4.Set the PC video output mode to VGA (640×480)/ SVGA (800×600)/ XGA (1024×768). In the mode higher than SXGA (1280×1024), "Out of Range" message appears. Be sure to change your PC video format to less than XGA mode. (Please refer to page 51 for the modes that PDP supports)
23