Planar PD520 Any white balance adjustments you make here are, Use it with caution, White Balance

You should save changes to any of the following settings to a preset; otherwise they will be lost when a new input source or resolution is selected:

•Brightness

•Contrast

•Color saturation

•Tint

•Sharpness

•Gamma

•Color temperature selection (5400, 6500, 8500 or Custom)

To save image settings to a preset, select Save Settings from the Installer menu and select “Vivid,” “Cinema,” “Standard” or “Custom.”

White Balance: To remove any trace of color from the white areas of the projected image, set the Color Temp. to Custom, Then, choose White Balance from the Installer menu and press ENTER.

•Gain: Use the Gain controls to correct color imbalances in the bright areas of the image. A good way to do this is to use a test pattern consisting mostly of solid white areas, such as an 80 IRE “window” pattern. If the white areas contain traces of red, green or blue, decrease the Gain for that color.

•Offset: Use the Offset controls in the White Balance sub-menu to correct color imbalances in the dark areas of the image. A good way to do this is to use a test pattern consisting mostly of dark gray areas, such as a 30 IRE “window” pattern. If the gray areas contain traces of red, green or blue, decrease the Offset for that color.

Any white balance adjustments you make here are

Note automatically stored as a “Custom” color temperature. The White Balance settings for the 5400K, 6500K and 8500K color temperatures are factory-set and cannot be changed.

Always set the Color Temp. to Custom before making any white balance adjustments, so you can see how those adjustments affect the image.

Blue Enable: Blue Enable removes all red and green color information from the image, simulating a blue filter. You can use it instead of a blue filter when performing color and tint adjustments.

Baud Rate: Select Baud Rate from the Installer menu to set the data transfer rate of the PD520’s RS-232 SERVICE port. (This setting must match the data rate of the device connected to the RS-232 input.)

Serial Link: Select Serial Link from the Installer menu to configure the RS-232 Service port (see Figure 3-9) for normal operation (On) or for software upgrades (Off).

Factory Reset: To reset all PD520 settings to their factory defaults, select Factory Reset from the Installer menu and press ENTER. This command is not undoable.

Use it with caution!

White Balance
R Gain	0
G Gain	100
B Gain	100
R Offset	50
G Offset	50
B Offset	50

Planar PD520 Owner’s Operating Manual 39