Installing PS5580 Displays on VESA Mounts
Note: If you plan to use the Planar Mounting System for these displays, skip this whole section and see the manual Planar PS5580 Planar Mounting System.
1Connect all cables to the panel and hang it in the lower left corner of the wall. Be sure the panel is level.
2Connect all cables for another display panel, and hang this panel. Hang this to the right of the first panel.
3Where the corners meet along the bottom edge, slip an alignment guide over the corner hardware on the back of the panels. The alignment guide should not protrude beyond the exposed edges of the panels.
4Check that both displays are level and straight.
5Tighten the screws for this alignment guide, compressing the nylon spaces until the guide is held in place.
6Where the corners meet along the top edge, slip an alignment guide over the corner hardware on the back of the panels. The alignment guide should not protrude beyond the exposed edges of the panels.
Note: If there are multiple rows, the alignment guide should protrude beyond the edges of the panels. However, if this is a
7Tighten all the screws for this alignment guide, compressing the nylon washer.
8Repeat steps
Intermediate Rows
1Attach all cables and hang the leftmost panel in this second row. The corner hardware should mate with the protruding hardware from the row below.
2Tighten the lower right corner screw so it holds the alignment guide.
3Where the corners meet along the left edge, slip an alignment guide over the corner hardware on the back of the panels. This guide should not protrude. Tighten the screws for this guide.
4Attach cables for the next panel and hang it as the next panel to the right in this row. Be sure the corner hardware mates with the protruding hardware next to it, and that everything is level and straight.
Indisys Management System: Setup and Operation | 10 |