Planar PS5580 manual Last Top Row, Removing a panel

Last (Top) Row

5Where the corners meet along the top edge, slip an alignment guide over the corner hardware on the back. This guide should protrude.

6Tighten the screws for this guide.

7Repeat the steps 1-6above until all rows except the top row are mounted.

Last (Top) Row

Do the steps for "Intermediate Rows" above, except the alignment guides along the top should not protrude.

Removing a panel

1To remove a panel, all panels above and to the right of the panel you need must be removed, starting with the panel in the upper right corner of the wall.

2For each panel that you remove:

a Slightly loosen all the corner screws that are accessible.

b Remove any alignment guides that are only connected to one other panel.

c Lift the panel to disengage it from the alignment brackets below and remove it from the wall.

3To rebuild the wall, reverse the steps taken for each panel, backtracking until the panel in the upper right corner is in place.

Indisys Management System: Setup and Operation 11