PREPARATION
INSTALLING THE INPUT
CARD
Optional input cards are necessary to use the functions of this monitor. Before mounting the monitor or connecting other equipment to the monitor, be sure to install the input cards.
1.Turn off the
2.Unscrew the screws and remove the slot cover from the slot (on the rear side of the monitor) in which you are going to install the card.
Slot cover
Rear side of the
3.Insert the Input Card’s board (green- colored) into the slot, fitting the board into the guide rails on the top and bottom of the slot.
Fit the board to the guide rails.
Knob
Guide rails
Input card (the illustration shown
is of the
Knob
4.Push the Input Card in so that its front panel touches the monitor’s rear panel.
5.Secure the Input Card by replacing the screws removed in Procedure 2.
NOTE : Do not touch the terminal connected to the monitor or board pattern.
Do not remove slot covers from the monitor’s slots if they are not in use.
8
ATTACHING THE WIDE
MASK
A wide mask is provided with the monitor. This changes the viewable screen area to the 16:9 aspect ratio.
The wide mask cannot be attached to the monitor after the monitor is mounted in a rack. Mount the wide mask before installing the monitor in a rack.
1.Prepare the provided wide mask and 4 screws (for attaching).
2.Attach the wide mask to the monitor.
3.Secure the wide mask with the screws (fix 2 screws each to both right and left side).
●When detaching the wide mask, follow this procedure in reverse.
8 | 01.3.27, 9:58 |