JVC Model HR-XVC1UJ manual Remote control, Inserting Batteries, Battery precautions

		Remote control
Inserting Batteries
1 Open the battery compart-	2 Install two "AA" batteries (supplied),	3 Replace the compartment
ment cover in the direction of	paying attention to the polarity	cover.
the arrow.	diagram in the battery compartment.

Battery precautions

The precautions below should be followed when using batteries in this device:

1.Use only the size and type of batteries specified.

2.Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device. To avoid a potential short circuit, insert the “–” end first.

3.Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.

4.If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.

5.Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer’s directions.)

Remote control basics

•Press POWER to turn the DVD/VCR on or off.

•Make sure TV/VCR/DVD switch is set to VCR/DVD.

•Tap VCR CH + or VCR CH –to move through the channels one channel at a time.

•The VCR CH +/–and SET +/–are also used to navigate on-screen menu system.

•You can directly access specific channels using Number keys pad.

•Each press of VCR or DVD, switches the screen between the VCR screen (VCR mode) and the DVD screen (DVD mode).

Operation
• Aim the remote control at the remote sensor and press control buttons
to operate.
• Operate the remote control within 30° angle on either side of the remote	Approx. 5 meters
sensor, up to a distance of Approx. 5 meters.

Change the custom code for remote control

If you operate this DVD/VCR with another JVC’s VCR simultaneously arranging them side by side, the both recorders will react to this remote control. In this case, you can change the remote control and DVD/VCR to other frequency (“ ”). Then you can operate only this DVD/VCR with this changed remote control.

When you purchased, the DVD/VCR and remote control have been set to the frequency-“ ”.

Example: Change frequency to

Remote control:

While holding VCR, press 2(code: b) of Number keys. (in case of code: A, press 1)

TV	VCR	DVD	POWER
DVDMENU	MARKER	RETURN	OPEN/
			CLOSE

	SUB TITLE	ANGLE	SEARCH
			MODE
SP/EP
PLAY	ZOOM	TITLE	REPEAT
MODE			A-B

TV

POWER

INPUT

TVVOL

0 TIMER TV/VCR

DVD/VCR:

In the POWER off mode,

press and hold PLAY for more than 5 seconds. “b”

will appear on the display	OPEN/CLOSE	REW FF	REC DVD
		PLAY STOP
and then disappear after
approx. 4 seconds.

NOTES:

•If the remote control has been set to b, the DVD/VCR also must be set to b. Otherwise, the DVD/VCR can not be operated with this remote control.

•To reset to “A”, repeat above procedure. However press 1 instead of 2.

11