Basic connections
If you are using an antenna system, follow these instructions. If you are a cable (CATV) subscriber,skip ahead to page 14 for the proper connections.
ANTENNA TO DVD/VCR CONNECTION
The DVD/VCR must be connected "between" the antenna and the TV. First, disconnect the antenna from the TV and connect it to the DVD/VCR.Then connect the DVD/VCR to the TV. Below are 3 common methods of connecting an antenna system to a DVD/VCR. Find the type of antenna system you are using and follow the connection diagram.
1
Combination VHF/UHF Antenna with 75 ohm Coaxial Cable
DVD/VCR
IN
(ANT.)
75 ohm Coaxial Cable
OUT (TV)
2
Combination VHF/UHF Antenna with 300 ohm Twin Lead (Flat) Wire
DVD/VCR
3
Matching Transformer |
|
300 ohm Input | IN |
75 ohm output | (ANT.) |
| |
(not supplied) | OUT |
| |
| (TV) |
300 ohm Twin Lead (Flat) Wire |
|
Separate VHF and UHF Antennas |
| DVD/VCR | |
|
| Combiner |
|
|
| 75/300 ohm Inputs |
|
| UHF | 75 ohm output |
|
VHF | (not supplied) |
| |
|
| ||
|
| IN | |
| 300 ohm Twin Lead (Flat) Wire | ||
| (ANT.) | ||
|
|
| OUT |
|
|
| (TV) |
| 75 ohm Coaxial Cable |
|
|
NOTE: If both VHF and UHF antennas have 300 ohm twin lead (flat) wires, use a combiner having two 300 ohm inputs and one 75 ohm output.
NOTES: •A clear picture will not be obtained by the DVD/VCR unless the antenna signal is good. Connect the antenna to the DVD/VCR properly.
•For better quality recording, an indoor antenna or a telescopic antenna is not recommended. The use of an outdoor type antenna is required.
•If you are not sure about the connection, please refer to qualified service personnel.
12