JVC S200BK manual To install batteries in the remote control unit, To connect the power cord

Page 18

Getting started

Getting started

To connect the power cord

When all the audio/video connections have been made, insert the smaller plug of the supplied AC power cord to the unit’s AC IN connector, then insert the other end to the wall outlet. Make sure that plugs are inserted firmly. The STANDBY indicator lights and setup is completed.

Warning

•Disconnect the power cord if you are not going to use the unit for a long time.

•Disconnect the power cord before cleaning the unit.

•Disconnect the power cord before moving the unit.

•Do not connect or disconnect the power cord with wet hands.

•Do not pull the power cord when disconnecting it, as this may damage the cord and cause fire, electric shock, or other accidents.

Warning

•Do not damage, alter, twist, or pull the power cord, as this may cause fire, electric shock, or other accidents.

•To prevent any accidents or damages caused by an unsuitable AC power cord, only use the supplied power cord. If the cord is damaged, contact a dealer and get the new power cord.

•Do not put anything heavy, or the unit, on the power cord, as this may cause fire, electric shock, or other accidents.

To install batteries in the remote control unit

The battery compartment is located on the back of the remote control unit.

1Press down on the point shown by the arrow at the top of the compartment cover,

and pull up the cover to open the compartment.

2 Place the two accessory R6P (SUM-3)/AA(15F) batteries in the remote control according to the polarity markings (“+” and “–”) inside the compartment and on the batteries.

3Place the cover over the compartment, and press down lightly.

•The batteries will last about six months with normal use. If the functions of the remote control become erratic, replace the batteries. See below for more information.

Precautions for the safe use of batteries

Observe the following precautions for the safe use of batteries. If they are used improperly their life will be shortened, they may burst or their contents may leak.

Precautions

•Remove the batteries from the remote control if it is not going to be used for a long period of time.

•Remove dead batteries and dispose of them properly.

•Never leave dead batteries lying around, take them apart, mix them with other refuse, or throw them into an incinerator.

•Never touch liquid that has leaked out of a battery.

•Do not mix new and old batteries, or batteries of different types, when replacing them.

16

Page 17 Page 19
Image 18
Page 17 Page 19
Contents 96% Mises en garde, précautions et indications diverses Table of Contents Features Supplied accessoriesIntroduction Other convenient procedures, etc Number indicates the procedural stepTo stop/quit random playback in the middle Safety precautions Important cautionsPreliminary knowledge Names of parts and controlsFront panel Remote control unit Numeric buttons Infrared signal-emitting window$ Cancel button 26 Angle button 29Display window Rear panelOpening displays Operational PrinciplesOn-screen displays Preference displaysStatus displays Play mode displaysTo prevent the monitor from burning out Screen Saver During Audio CD/MP3 CD During Video CD/SVCD PlaybackAbout invalid operation icon How to use numeric buttonsOn-screen guide icons To select a track/title numberDisc structure About discsPlayable disc types Playable discsBefore making any connections Getting startedConnections To connect to a TVBlue Green Red Component video cable Not supplied To connect to a TV with the component video input jacksEnabling the Component Video OUT Red White Audio cable not supplied Blue Green RedTo connect to an audio amplifier or receiver To connect to audio equipment with a digital inputRed White Audio cable not supplied Amplifier or receiver Precautions for the safe use of batteries To install batteries in the remote control unitTo connect the power cord PrecautionsInserting and removing discs Basic operationsTurning on/off the unit Press 0 OPEN/CLOSE to close the disc trayTo stop playback completely Basic playbackTo start playback To stop playback temporarilyTo memorize the interrupted position Resuming playbackTo locate the beginning of the scene or song To resume playbackTo locate a desired scene from the DVD menu Advanced operationsPlaying from a specific position on a disc Press Title or MenuTo locate a desired selection using 4 or ¢ Use the numeric buttons to specify the numberFor DVD Video During playback Press Enter Press Play ModeSEARCH, then press Enter Use Cursor 2/3 to move to Time SEARCH, then press EnterTo locate a desired scene from the display Digest Use the numeric buttons 0 to 9 to enter the timePress Digest Special picture playback Use Cursor 5/∞/2/3 to select the desired scenePress and hold 8 for more than 1 second Press 8, then use 1 / ¡ To playback in slow-motion SlowTo zoom a scene Zoom Press ZoomChanging the playback order To playback in the desired order ProgramPress 3 to start program play To repeat the current selection or all tracks Repeat Repeat playbackTo playback in random order Random Use Cursor 2/3 to move to RandomTo quit repeat playback To repeat a desired part A-B RepeatAudio CD/Video CD/SVCD For Audio CD For Video CD/SVCD Unit locates a and starts repeat playback between a and BUse Angle or Cursor 2/3 to select the desired angle To select a scene angle from the normal screen AnglePress Angle To quit A-B repeat playbackChanging the language and sound List display AngleTo select the subtitle language Subtitle Use Audio or Cursor 2/3 to select the desired audio To change the audio language or sound AudioPress Audio For DVD Video For Video CDTo select the picture character Selecting the picture characterEnjoying virtual surround sound To simulate surround sound 3D PhonicChecking the status To check the disc/time informationTo turn off the disc/time display Press Display Dimning brightness of the display window To dim the brightness of the display windowTo check the DVD function status Press DisplayAbout MP3 CD disc Basic operations using the basic control buttonsMP3 CD playback Unavailable functionsAdvanced functions Track/Group selection using the numeric buttonsHow to select a Track or Group Program playbackWindow on the front panel. After playing all groups Random playbackYou can playback Groups on an MP3 CD disc in random order Disc, random playback endsUse Cursor 2/3 to move to REPEAT, then press Enter Repeat playbackDisc/time information You can repeat playback of the current Group or all GroupsSelecting preferences Initial settingsHow to set preferences LanguageAudio Display System Limiting playback by children To set Parental Lock for the first timeWhile points Country Code, use Screen display appears To change the settings Parental LockPress Enter while holding down 7 on the remote control unit On the TV screenEnter your 4-digit password using the numeric buttons 0 to Use the Cursor 5/∞ to move to YES, then press EnterAdditional information Care and handling of discsTroubleshooting Symptom Possible case RemedySpecifications Appendix ATable of languages and their abbreviations Appendix BCountry/Area code list for parental lock Do not service the television yourself Toll Free 1 800Limited Warranty For customer useJVC 0702MZMCREJSC
Top Page Image Contents