JVC XV-FA90BK Troubleshooting, Symptom Possible case Remedy, Indicator on the front panel is lit

Page 70

Additional information

Additional

information

 

 

Troubleshooting

What appears to be a malfunction may not always be serious. Please go through the following list before requesting service.

Symptom

Possible case

Remedy

 

 

 

 

 

 

Power does not come on.

Power plug is not inserted securely.

Plug in securely.

 

 

 

 

 

 

 

 

 

 

Too far from the unit.

More closer to the unit.

 

 

 

 

 

 

 

 

 

 

The tip of the remote unit is not pointed in

Point the infrared light- emitting window

Remote control does not work.

the right direction.

toward the remote sensor on the front panel.

 

 

Batteries are exhausted.

Replace the batteries with new ones.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Battery polarity is incorrect.

Take out the batteries and insert them again in

 

 

 

 

the correct direction.

 

 

 

 

 

 

 

 

 

 

 

The TV/VIDEO - CANCEL, CURSOR or

 

To control the unit, set the TV - DVD switch to

The TV - DVD switch is not correctly set.

“DVD”. To control your TV, set the TV - DVD

numeric buttons do not work.

 

switch to “TV”.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Connection of video cable is incorrect.

Connect the cable correctly.

No picture is displayed on the

 

 

Input selection of TV is incorrect.

Select correctly.

monitor.

 

 

 

 

 

 

Disc is not playable.

Use a playable disc. (See page 15.)

 

 

 

 

 

 

Picture is not normal when using the

The Y/C - COMP. switch is not set

Set the Y/C - COMP. switch correctly.

VIDEO or S-VIDEO jack.

correctly.

(See page 10.)

 

 

 

 

 

 

Picture is noisy or blurred.

The unit is connected to a VCR directly

Connect the unit so that the picture signal

and the copyguard function is activated.

flows directly to the TV.

 

 

 

 

 

 

 

 

 

 

No audio is reproduced.

Connection is incorrect.

Check the connections.

 

 

Input selection of amplifier is incorrect.

Select correctly.

 

 

 

 

 

 

 

 

 

 

No audio is reproduced when playing

 

 

back a DVD disc recorded with High-

The audio signal is not derived from the

Use the AUDIO OUT when playing back such

sampling (88.2 kHz or more) linear

unit's DIGITAL OUT.

discs.

PCM audio using the DIGITAL OUT

 

 

jack.

 

 

 

 

 

 

 

 

There is no sound.

The disc has been illegally copied.

Consult with disc vendor.

NO AUDIO is displayed.

 

 

 

 

 

 

 

 

Sound is distorted or noise is

Disc is dirty.

Wipe the disc surface.

generated.

 

 

 

 

 

 

 

 

Picture does not fit the television

MONITOR TYPE is not correctly set.

Select monitor type correctly. (See page 59.)

 

 

screen.

Television is not correctly set.

Set the television correctly.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Microcomputer malfunction due to

Turn off the power and unplug the power

 

 

 

 

lightning or static electricity.

cord, then connect the power cord again.

Operation is not possible.

 

 

Moisture condensation caused by a

Turn off the power, then turn it on a few hours

 

 

 

 

 

 

 

 

sudden change of temperature or

 

 

 

 

later.

 

 

 

 

humidity.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

The system malfunctions.

 

The carousel does not move.

An alien substance is jammed on the

Press the STOP button or turn off the power.

 

 

 

 

carousel.

 

 

 

 

 

 

 

The display window does not

 

 

light when the STANDBY/ON

 

 

 

The brightness of the display window is

Change the brightness of the display window.

 

 

 

indicator on the front panel is lit

set to “off”.

(See page 52.)

in green.

 

 

 

 

 

 

 

 

68

Page 69 Page 71
Image 70
Page 69 Page 71
Contents $%.9$6 Class Laser Product Table of Contents Features IntroductionSupplied accessories Press and hold Angle for more than 1 second To select a scene angle from the angle list display Angle¶ During DVD Video playback Safety precautions Important cautionsNames of parts and controls Preliminary knowledgeFront panel Display window Remote control unit Previous button 29, 35 @ Infrared signal-emitting windowTV/VIDEO Cancel button 24 Clear button 29, 40Rear panel Basic operations of on-screen displays Operational PrinciplesOn-screen displays Opening displayDVD Control for DVD Video display Parental Lock display seeDVD Control for DVD Audio display VCD Control display To prevent the monitor from burning out Screen SaverCD Control display MP3 Control display seeHow to use numeric buttons On-screen guide iconsAudio formats About discsPlayable disc types Playable discsDisc structure Before making any connections Getting startedConnections To connect to a conventional TVCOMP. switch To connect to a TV with the Scart connectorScart cable not supplied Unit Red White Audio cable To connect to an audio amplifier or receiverAmplifier or receiver Audio/Video Cable Supplied Supplied Amplifier or receiverOptical digital cable not supplied To connect to audio equipment with a digital inputRed To connect the power cord Using the remote control unitTo install batteries in the remote control unit Precaution Precautions for the safe use of batteriesRemote sensor You can operate your TV from the remote control unit To use the remote control unit for TV operationSetting the remote control signal for operating your TV Manufacturer code list+10 Inserting and removing discs Basic operationsTurning on/off the unit Press0 OPEN/CLOSE on the front panelTo insert an 8-cm disc Place one or two discs in the traysWith the label side up Place it in the inner recessBasic playback About Disc indicators 1 throughTo start playback To stop playback temporarily Method 1 from the remote control unit onlyTo stop playback completely To advance or reverse playback rapidly while monitoringPress 4 or ¢ To locate the beginning of the scene or songChanging discs during playback Play Exchange Press EXCHANGE/ Disc SkipTo memorize the interrupted position Resuming playbackTo resume playback Audio Video Advanced operationsFunction Playing from a specific position on a discUse the numeric buttons to select the desired item To locate a desired scene from the DVD menuPress TOP Menu or Menu ExampleUse the numeric buttons to specify the number Unit status Disc type What is SpecifiedWhen appears on the TV screen For an Audio CD or Video CD, a track is SpecifiedPress Enter To locate a desired selection using 4 or ¢Press on Screen Message area For DVD AudioUse the numeric buttons 0 to 9 to enter the time Use Cursor 5/∞ to move to Time SEARCH, then press EnterScreen example Press Digest When you make a mistakeTo locate a desired scene from the display Digest Use Cursor 5/∞/2/3 to move to select the desired sceneTo display continuous still pictures Strobe To cancel strobe playSpecial picture playback Press and hold 8 for more than 1 secondTo return to normal playback Press Enter Use Cursor 5/∞/2/3 to move the zoomed positionPress Zoom + or ¶ During playback or while paused3a for Audio CD/Video CD Changing the playback orderTo playback in the desired order Program Use Cursor 5/∞ to move to Program and press EnterTo quit program playback To playback in random order RandomUse Cursor 5/∞ to move to Random To quit random playback in the middlePress Repeat Repeat playbackTo repeat the current selection or all tracks Repeat During DVD Video playbackDisc type Display window On-screen display Selected repeat mode For Video CDAudio CD/Video CD To stop repeat playback PressFrom normal screen Selecting a scene angleTo select a scene angle from the normal screen Angle Press AngleUse Cursor 2/3 or Angle to select the desired angle number From on-screen displayUse Cursor 5/∞ or Angle to move to Angle Total number of recorded anglesTo select the subtitle language Subtitle Changing the language and soundFrom on-screen display DVD Video only Press Audio S.FREQ To change the audio language or sound AudioUse Cursor 5/∞ or Audio S.FREQ to move to Audio For DVD AUDIO/DVD VideoSelected preset To adjust the picture character VFPPress VFP to select the desired preset Miscellaneous functionsSelected effect mode Adjust the level of the parameter using Cursor 2/3Select the desired mode by using 3D Phonic To simulate surround sound 3D PhonicUse Cursor 5/∞ to move to Time Select Press Cursor 2/3 to adjust the effect levelDuring playback for DVD AUDIO/Audio CD Use Cursor 5/∞ or page to move to To select a still picture on a DVD Audio discFrom normal display Use Cursor 2/3 or page to select the desiredPress Cursor 5 or ∞ while holding down ¶ When no disc is insertedTo playback a bonus group of a DVD Audio disc Display Window TV screenChecking the sampling frequency Press Audio S.FREQ for more than one secondOperations MP3 disc playbackAbout MP3 disc Basic operationsSpecifying the desired Group and Track Highlight a desired Group using Cursor Press EnterHighlight a desired Track using Cursor Track timeYou can repeat playback of the current track or group You cannot repeat all contents on discRepeat playback ¶ During playback or while stoppedSelecting preferences Initial settingsHow to set preferences Language and display preferenceEnglish Setting changes as followsSelected language FrenchAudio and system preference Lt/Rt Only for Dolby Digital DVD Video DiscsOutput Playback discs L0/R0Back DTS-encoded DVD This item controls Output signals when playingDefault setting DVD1 Video discsBass redirect Available only when selecting Expert Speaker settingSpeaker Channel setting Speaker size settings Available only when selecting ExpertTest tone Available only while setting Level or Delay Available only when selecting ExpertLimiting playback by children To set Parental Lock for the first timeTo change the set level, use Cursor 2/3 to To change the settingsPoints Password Screen display appearsEnter your 4-digit password using the numeric buttons 0 to Use the Cursor 5/∞ to move to YES, then press EnterAdditional information Care and handling of discsDisplay window does not Light when the STANDBY/ON TroubleshootingSymptom Possible case Remedy Indicator on the front panel is litSpecifications Appendix ATable of languages and their abbreviations Appendix BCountry code list for Parental Lock Above ALL
Top Page Image Contents