Getting started
To use the remote control unit for TV operation
You can operate your TV from the remote control unit.
Setting the remote control signal for operating your TV.
1Holding down TV/VIDEO, enter the manufacturer code of your TV listed below by using the numeric buttons (0 - 9). Do not release TV/VIDEO. Keep holding it until the next step is completed.
Manufacturer code list
No. | Manufacturer |
|
|
01 | JVC |
|
|
02 | JVC |
03 | JVC |
|
|
04 | JVC |
|
|
05 | THOMSON |
|
|
06 | FERGUSON |
|
|
07 | PHILIPS |
|
|
08 | GRUNDIG |
|
|
09 | SONY |
|
|
No. | Manufacturer |
|
|
10 | PANASONIC |
|
|
11 | ITT |
12 | MIVER |
|
|
13 | HITACHI |
|
|
14 | TOSHIBA |
|
|
15 | MITSUBISHI |
|
|
16 | FINLUX |
|
|
17 | NOKIA |
|
|
18 | SHARP |
|
|
No. | Manufacturer |
19SAMSUNG
20FUNAI
21GOLDSTAR
22NEC
Example:
To enter the manufacturer code “01”: Press “0” then “1.”
Getting | started |
2Press 7 (STOP) while holding down TV/VIDEO.
The following buttons can be used for operating the TV:
| TV |
|
| DVD | Turns the TV on or off. |
SHIFT |
| |
|
| |
TV |
| Changes the TV channels. |
ch |
|
|
TV |
| Adjusts the TV volume. |
VOL |
|
|
|
| Selects the TV channels. |
SHIFT |
| *For some TVs, pressing “+10” while holding down SHIFT |
|
| |
1 to | 10 | functions as the |
if your TV requires pressing the ENTER button after selecting a | ||
TV 1 |
| channel number. |
0 | +10 | |
TV 0 | TV |
|
TV/VIDEO
Switches input mode (either TV or VIDEO).
3Try to operate your TV by pressing DVD 
- TV 
while holding SHIFT. If your TV turns on or off, you have successfully set the control signal.
NOTES
•The remote control unit is initially set for operating a JVC TV.
•If there is more than one code listed for the manufacturer of your TV, try them one by one until you succeed.
To control the volume of a JVC’s amplifier or receiver
You can control the volume of a JVC’s amplifier or receiver by using the AMP VOL button on the remote control unit.
AMP
VOL
16